ELECTRICAL CONNECTION
- Before inserting the plug in an electrical outlet, check carefully to be certain that the voltage in
your home’s electrical system matches the voltage indicated on the appliance and that the
socket and main feed are of a size sufficient to power this appliance.
- THIS APPLIANCE COMPLIES WITH EEC DIRECTIVE 89/336 REGARDING ELECTROMAGNE-
TIC COMPATIBILITY.
FUNCTIONING AND USE
Models with function selector and ambient thermostat
-
Turn the thermostat knob (where included) in a clockwise direction until it reaches the maxi-
mum setting.
-
Summer service (ventilation only): turn the functions knob to setting .
-
Heating at reduced power: turn the functions knob to setting 1.
-
Heating at full power: turn the functions knob to setting 2.
-
Switching off: turn the functions knob to setting 0.
It is always advisable to disconnect the plug when the appliance is not in use.
Models with thermostat only
The appliance is switched on by turning the knob in a clockwise direction until it reaches the maxi-
mum setting. To switch the appliance completely off turn the knob to the minimum setting and
remove the plug from the electrical socket.
REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the thermostat knob in an anti-clockwi-
se direction up to the point where the appliance switches off and not beyond. The temperature
fixed in this way will be automatically regulated and kept at a constant level by the thermostat.
ANTIFREEZE SERVICE
Turn the functions knob to setting 2, then turn the thermostat knob to setting . When it is set in
this way the appliance keeps the room at a temperature of approx. 5° C with minimal energy
expenditure.
CLEANING AND MAINTENANCE
Before cleaning always remove the plug from the electrical socket.
Clean the air inlet/outlet grilles frequently with a vacuum cleaner.
Never use abrasive powders or solvents.
WARNINGS
- Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming pools,
etc.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger
of overheating).
- The heater must be positioned at least 50 cm from furniture or other objects.
- Do not place the appliance up against walls, furniture, curtains, etc.
- The appliance must be installed so that the controls can not be reached by persons using the
bath tub or the shower.
- If the power supply cable is damaged, it must be replaced by the manufacturer or its technical
support service or by a person with a similar qualification in order to avoid all risks.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not block the hot-air outlet grilles or the intake grille located on the bottom of the appliance.
- Do not use the appliance in rooms less than 4 m
2
in area.
Never cover this appliance in any manner whatsoever while it is operating,
because by doing so you will cause a dangerous increase in the temperature of
the appliance itself.
The heater is fitted with a safety device which will switch off the heater in case of accidental
overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all). To
reset, disconnect the plug from the power for a few minutes, remove the cause of overheating then
plug the appliance in again.
GB
3
