182IDL/09.02
Kettle KBC3010/ KBX3010
Electrical Requirements
The flexible mains lead is supplied connected to a B.S. 1363
fused plug having a fuse of 13 amp capacity.Should this plug not
fit the socket outlets in your home, it should be cut off and
replaced with a suitable plug, following the procedure outlined
below.
Note: Such a plug cannot be used for any other appliance and
should therefore be properly disposed of, (having removed the
fuse) and not left where children might find it and plug it into a
supply socket - with the obvious consequent danger.
If the plug is a moulded-on type the fuse cover must be refit-
ted. If the fuse cover is lost, the plug must not be used until a
replacement cover is obtained.The colour of the correct replace-
ment fuse cover is that of the coloured insert in the base of the
fuse recess or elsewhere on the plug.Always state this colour
when ordering a replacement fuse cover.
N.B.We recommend the use of good quality plugs and wall sockets
that can be switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected
to the terminal in the plug which is marked with the letter E or by
the earth symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the termi-
nal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the ter-
minal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely
retained in each terminal. Do not forget to tighten the mains lead
clamp on the plug. If your electricity supply point has only two pin
socket outlets, or if you are in doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that
this operation be carried out by a qualified electrician and should
only be replaced with a flexible cord of the same size.
Only 13amp replacement fuses which are asta approved to B.S.
1362 should be fitted.
This appliance conforms to the Norms EN 55014 regarding the
suppression of radio interference.
Green and Yellow to
Earth
Blue to
Neutral
13 amp
Fuse
Brown to
Live
Cord Clamp
Warning
this appliance must be earthed
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
8
