26
SETTING THE TIMER
The timer can be used to delay appliance start up or shut down.
This avoids wasting electricity by optimising operating periods
How to programme delayed start up
• Plug the appliance into a mains socket and press the ON/STAND-BY button (A), then select
the required operating mode and other settings (temperature, fan speed, etc).
•Press the ON/STAND-BY button (A) again. The appliance switches to stand-by mode.
•Press the TIMER button (H): the last timer setting or the preset value 6.0 h flashes on the dis-
play.
66 .. 00
h.
•Use the + (G) or - (I) buttons to set the number of hours delay before the appliance comes
on.
During the first ten hours, you can select half hour intervals.
For times greater than ten hours, one hour intervals can be selected. If the "+" (G) or "-" (I)
buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24
hours. Press the timer button again within a few seconds to confirm the setting. If the setting
is not confirmed within a few seconds, the display resets to stand-by.
With the timer activated, the countdown before the programmed start up time is displa-
yed.
To cancel the timer programme, press the timer button (H).
How to programme delayed shutdown
• Delayed shutdown can be set with the appliance in any operating mode - air conditio-
ning/dehumidifying/fan.
•Press the Timer button (H) the last timer setting or the preset value
66 .. 00
h. flashes on the dis-
play.
•Use the + (G) or - (I) button to set the number of hours delay before the appliance goes off.
During the first ten hours, you can select half hour intervals.
For times greater than ten hours, one hour intervals can be selected. If the "+" (G) or "-" (I)
buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24
hours. Press the timer button again within a few seconds to confirm the setting.
At the set time, the air conditioner shuts down and remains in stand-by. To cancel the timer
programme, press the timer button (H).
26
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
LOW TEMPERATURE
(FROST PREVENTION)
pf PROBE FAILURE
(SENSOR DAMAGED)
FULL TANK
When the appliance is operating in air conditioning or dehumidifying
mode, this device prevents the formation of ice. The appliance starts up
again automatically when the defrosting process is completed.
If this is displayed, contact your service centre.
Empty the internal safety tank, through the drain hose.
see page 31 "end of season operations"
IF ... IS DISPLAYED ...WHAT SHOULD YOU DO?
