Bedienungsanleitung DeLonghi PAC EM77 (Seite 13 von 124) (Alle Sprachen)

800380

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

INTRODUCTION

Thank you for choosing this De’Longhi product. Please take a few

minutes to read these instructions. This will prevent running any

risks or damaging the appliance.

DESCRIPTION

Description of the appliance (see page 2 - A)

A1 Air outlet grille

A2 Control panel

A3 Handles

A4 Wheels

A5 Filter

A6 Air intake grille

A7 Air exhaust hose housing

A8 Air intake grille

A9 Power supply cable

A10 Upper drainage hose with cap

A11 Lower drainage hose with cap

A12 Remote control signal receiver

A13 Remote control compartment

Description of accessories (See page 2 - B)

B1 Air exhaust hose

B2 Hose adapter

B3 Adapter for extendable window bracket/window

B4 Extendable window bracket with screws

B5 Drainage tube

B6 Self adhesive strips foam (2 pieces)

B7 Non adhesive strip foam

B8 Remote control

ELECTRICAL CONNECTION

Before plugging into the mains, check the following:

• the mains voltage is the same as that indicated on the plate

on the back of the appliance;

• the socket and electrical line are sized to support the load

required;

• the socket is the proper type for the plug, otherwise, re-

place the socket;

• the socket is connected to an ecient earthing system. The

manufacturer is not responsible in the event of non-com-

pliance with these injury prevention standards.

• The power cable must only be replaced by special-

ised technicians.

USE

The instructions below will enable you to prepare your air con-

ditioner for operation as eciently as possible. Before use, make

sure the air intake and outlet grilles are unobstructed.

Maintain a minimum distance of 60 cm from walls and obstacles.

In conditioning and dehumidication the air exhaust hose (B1)

must be applied (Fig. 1).

Please note: This appliance is provided with an auto-evapora-

tion feature for condensate removal during cooling and dehu-

midifying mode.

AIR CONDITIONING WITHOUT INSTALLATION

CASEMENT WINDOW

If you have a casement window proceed as follows:

• Fit the air exhaust hose (B1) in the relevant housing located

on the rear side of the appliance (Fig. 1).

• Position the air exhaust hose (B1) with the window adapter

(B3) outside the window to let the hot air out (Fig. 2).

DOUBLEHUNG WINDOW

Depending on the need, place the self adhesive strips foam or

non adhesive strip foam on the window as shown in gure 3.

• Cut the adhesive strips foam to the desired length and pla-

ce it on the window.

• Position the extendable window bracket on the window sill

and fully extend the extendable window bracket inside the

window frame (Fig.4)

• Adjust the extendable window bracket by xing the length

with two screws (Fig. 5) (If the extendable window bracket

is too large, it is possible to cut the plastic using a saw. This

operation must be carried out by a qualied professional).

• Hook the adapter for extendable window (B3) to the win-

dow bracket as shown in Fig. 6.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi PAC EM77 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info