Bedienungsanleitung DeLonghi PAC ES Pinguino (Seite 13 von 123) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

800385

Zoom out

Zoom in

Vorherige Seite

1/123

Nächste Seite

INTRODUCTION

Thank you for choosing this De’Longhi product. Please take a few

minutes to read these instructions. This will prevent running any

risks or damaging the appliance.

DESCRIPTION

Description of the appliance (see page 2 - A)

A1 Air outlet grille

A2 Control panel

A3 Handles

A4 Wheels

A5 Rear lter

A6 Side lter

A7 Air intake grille

A8 Air exhaust hose housing

A9 Air intake grille

A10 Power supply cable

A11 Upper drain connection with cap

A12 Lower drain connection with cap

A13 Remote control compartment

Description of accessories (See page 2 - B)

B1 Air exhaust hose

B2 Hose adapter

B3 Adapter for wall mounting /window

B4 Adapter for window

B5 Wall ange with cap

B6 Remote control

ELECTRICAL CONNECTION

Before plugging into the mains, check the following:

• the mains voltage is the same as that indicated on the plate

on the back of the appliance;

• the socket and electrical line are sized to support the load

required;

• the socket is the proper type for the plug, otherwise, re-

place the socket;

• the socket is connected to an ecient earthing system. The

manufacturer is not responsible in the event of non-com-

pliance with these injury prevention standards.

• The power cable must only be replaced by special-

ised technicians.

USE

The instructions below will enable you to prepare your air con-

ditioner for operation as eciently as possible. Before use, make

sure the air intake and outlet grilles are unobstructed.

Maintain a minimum distance of 60 cm from walls and obstacles

(Fig. 3).

In conditioning and dehumidication the air exhaust hose (B1)

must be applied (Fig. 1).

Please note: This appliance is provided with an auto-evapora-

tion feature for condensate removal during cooling and dehu-

midifying mode.

AIR CONDITIONING WITHOUT INSTALLATION

CASEMENT WINDOW

If you have a casement window proceed as follows:

• Fit the air exhaust hose (B1) in the relevant housing located

on the rear side of the appliance (Fig. 1).

• Position the air exhaust hose (B1) with the window adapter

(B4) outside the window to let the hot air out (Fig. 2).

AIR CONDITIONING WITH INSTALLATION

If desired, the appliance can also be installed in a semi-perma-

nent manner.

In this case, it is necessary to:

• Drill a hole (diam. 150 mm) in a perimeter wall, or through

the glass of a window. Respect the height and dimensions

of the hole indicated in the gure shown below.

150

MAX 100 cm

MIN 35 cm

• Apply the supplied ange accessory B5 in the hole.

• Position the air exhaust pipe (B1) in the dedicated seat at

the rear of the appliance (g. 1).

• Attach the end of the pipe B1 to the ange B5 as shown in

g. 9.

Limit the length and bends in the air pipe as much as pos-

sible, avoiding any bottlenecks.

in the glass

of the

window

in the wooden

base of the

French window

in the wall

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi PAC ES Pinguino Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info