Bedienungsanleitung DeLonghi PACEL112 CST (Seite 5 von 8) (Englisch)

770068

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Perfect!

HUMIDITY

TEMPERATURE

HIGH

MEDIUM

LOW

HIGH

MEDIUM

LOW

Operating curve

Perfect!

ORANGE LIGHT: Room conditions far

from optimal level.

GREEN LIGHT: Most people feel good

room conditions, near optimal level.

BLUE LIGHT: Best comfort level.

• The well-being feeling is a subjective condition: for this

reason, dierent people may judge dierently the same

environmental conditions.

• In particularly severe environmental conditions (large size

of the environment, high temperature or humidity outside,

poor insulation of the room, too many of people or strong

heat load in the room, strong exposure to the sun ...) this

device may not be able to reach the best comfort level.

SILENT FUNCTION

(available in conditioning mode

only)

By activating this function, the operating noise is further re-

duced. To activate it, touch on the remote control the but-

ton (D2). The display shows the relative symbol (C12).

SWING FUNCTION

This function moves the ap evenly distributing the air into the

room.

When the Swing button (D9) is touched, the ap will begin

to move forwards and backwards alternatively.

If touched again, the ap will be locked into its current position.

When the button is next touched, the ap will start to move for-

wards and backwards again.

Please note: in order to avoid damaging the internal mecha-

nisms, the ap must not be moved manually.

REPEAT PAIRING OF CST REMOTE CONTROL

The CST remote control is already paired to the bundled Pinguino

appliance. In case the user wants to perform a pairing with an-

other Pinguino device, or in case of a pairing of brand new CST

remote control, the user needs to put the unit in Stand-by mode

and keep touched for 10 sec sthe MODE selection button (D6) on

the CST remote control. The Led (D10) starts blinking periodi-

cally indicating the pairing phase.

The user is then asked to press for 10 sec the MODE button (C2)

on the Pinguino unit until a double beep is emitted. The pairing

phase is signaled on display by means of a fast ashing of the

dot in the middle of the digits.

When the two devices complete the pairing dialogue, the PAC

emits a double ‘beep’, the display will show the normal visualiza-

tion for Standby. The pairing must be done within 60 sec.

SETTING THE TIMER

The timer allows the delayed start up or shut down of the appli-

ance. This function will prevent wasting electricity by optimising

the operating periods.

How to program delayed shut down

• While the appliance is on in any operating mode, delayed

shut down can be programmed.

• Touch the

C1C2

C11

C13

C12

C16

C14

C10

C15

C17

timer button (D5): the timer symbol (C7) and

hours (C6) light up.

• Touch the (D4) and (D7) buttons until the desired

numbers of hours to shut down appears on the display.

A few seconds after the timer is set, the setting is acquired, the

display shows the operating mode and the timer symbol stays lit.

Once the set time is elapsed, the air conditioner goes into stand-

by.

To cancel the timer program, touch the

C1C2

C11

C13

C12

C16

C14

C10

C15

C17

timer button (D5)

twice. The timer symbol (C7) will go o.

Please note: Once the timer has been activated, by touching the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeLonghi PACEL112 CST Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeLonghi PACEL112 CST

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info