Bedienungsanleitung Denon AVP-A1HDCI (Seite 102 von 124) (Englisch)

571793

102

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

If a problem should arise, ﬁrst check the following:

1. Are the connections correct?

2. Is the set being operated as described in the owner’s manual?

3. Are the other components operating properly?

If this unit does not operate properly, check the items listed in the table below. Should the problem persist,

there may be a malfunction.

In this case, disconnect the power immediately and contact your store of purchase.

Symptom Cause Countermeasure Page

Power does not

turn on, or turns

off directly after it

was turned on.

• Connection of the power cord is

faulty.

• Check that the power plug is

securely inserted into the AVP-

A1HDCI’s AC inlet and the wall

power outlet.

No sound is

produced from

speakers.

• The connection with the input

devices or power amp is faulty.

• Device you want to play and set

input source do not match.

• Master volume is turned too

low.

• Mute mode is set.

• Headphones are connected.

• No digital signals are being

input.

• The connectors to which the

digital inputs are assigned and

the settable input modes do not

match.

• Check the connections.

• Select an appropriate input

source.

• Adjust the master volume to an

appropriate level.

• Cancel the mute mode.

• Disconnect the headphones.

• Select an input source for which

the digital input setting has been

made.

• Set the input mode.

43, 46, 47

Display is off. • The “Dimmer” setting is set to

“OFF”.

• The PURE DIRECT mode is set.

• Set to something other than

“OFF”.

• Set a surround mode other than

the PURE DIRECT mode.

“DOLBY DIGITAL”

indicator does not

appear on display.

• DVD player’s digital audio output

setting is not proper.

• Check the DVD player’s audio

output setting. For details, read

the DVD player’s operating

instructions.

–

Symptom Cause Countermeasure Page

Power turns off

suddenly and

power indicator

ﬂashes red.

• Set is damaged. • Turn off the power and contact a

DENON service center.

–

GGeneralH

Symptom Cause Countermeasure Page

Set does not work

properly when

remote control

unit operated.

• Batteries are worn.

• You are operating outside of the

speciﬁed range.

• Obstacle between main unit and

remote control unit.

• The batteries are not inserted in

the proper direction, as indicated

by the polarity marks in the

battery compartment.

• The set’s remote control sensor

is exposed to strong light (direct

sunlight, inverter type ﬂuorescent

bulb light, etc.).

• The remote ID of the main unit

and remote control unit do not

match.

• Replace with new batteries.

• Operate within the speciﬁed

range.

• Remove the obstacle.

• Insert the batteries in the

proper direction, following the

polarity marks in the battery

compartment.

• Move the set to a place in which

the remote control sensor will

not be exposed to strong light.

• Set the same remote IDs for the

main unit and remote control

unit.

3, 4

–

3, 4

41, 76, 81

GRemote Control UnitH

Troubleshooting



Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting

AVPA1HDCIEU_0121.indd 102 2008/01/21 12:50:35

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denon AVP-A1HDCI Seite 102

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Denon AVP-A1HDCI

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info