36
Learning function
If your AV component is not a Denon product or if it cannot be operated using the preset memory, it can be controlled with the accessorious
remote control unit by storing its remote control signals in the remote control unit.
For some remote control signals it is not possible to “learn” the signals or the device will not operate properly. In such cases use the remote
control unit included with the device to operate it.
1
Press the USE/LEARN button with the tip of a pen etc., to set
the learn mode.
• Both the mode selector buttons and LEARNED/TX indicator
flash.
2
Press the mode button of the equipment for which learning is
desired.
• Mode button and LEARNED/TX indicator flash.
3
Press the button that is to be learned.
The LEARNED/TX indicator stops flashing and the mode
button lights.
• Mode button and LEARNED/TX indicator flashed if a button
that cannot be “learned” is pressed.
• To cancel, press the USE/LEARN button.
4
Point the remote control units directly at each other and press
and hold in the button on the other remote control unit which
you want to “learn”.
5
The mode button and the LEARNED/TX indicator lights,
release the button on the other remote control unit.
• The mode button and the LEARNED/TX indicator start
flashing again.
6
To “learn” other buttons, repeat steps 2 to 5.
Other remote
control unit
7
Once the learning operation is completed, press the
USE/LEARN button again.
The mode button and the LEARNED/TX indicator stop flashing
and the learning mode is cancelled.
Flashes
Check that the stored codes
work properly.
NOTES:
• If the codes could not be stored, the LEARNED/TX indicator
start flashing rapidly. For limited number of models, codes
cannot be stored in RC-924.
• If the mode button and LEARNED/TX indicator start flashing
rapidly, this means that the memory is already full, and the code
you have just attempted to store was not stored.
To “learn” that code, first perform the resetting operation. (See
page 39.)
