10
Easy Setup and Operation Easy Setup and Operation
Connecting a microphone
1
Connect the microphone for Auto Setup to the
SETUP MIC jack on the front panel of the unit.
2
Mount the auto setup microphone onto a camera
tripod, etc., and place it at ear height at the main
listening position in the listening room with the
sound receptor facing the ceiling.
Microphone
NOTE:
• Do not disconnect the microphone until the settings are
completed.
• Do not change the connection of speakers or the
subwoofer’s volume after performing these measurements.
When placing the microphone, adjust the height so that the
microphone’s sound receptor is at the height of the ears of
the listener.
Be sure that at the beginning, the measurement is started
with the microphone set up at the main listening position.
It is not possible to measure properly if there are any
obstacles between the speakers and microphone. Check
that there are no obstacles.
Please do not stand between or near the speakers and the
microphone during the measurements.
4
Press the ON/STANDBY switch on the main unit
or ON button on the remote control unit.
• When pressed, the power turns on and the display lights.
• When pressed again, the power turns off, the standby
mode is set and the display turns off.
3
Press the POWER switch.
£ OFF:
The power turns off and the indicator is off.
In this position, the power cannot be turned on and off from
the remote control unit.
¢ ON:
The power turns on and the indicator lights.
Set the POWER switch to this position to turn the power on
and off from the included remote control unit.
1
Turn on your subwoofer.
Turn on your monitor (TV).
Turning on the power
5
Press the AMP button to select “AMP” mode
(only when operating with the remote control
unit ( page 24)).
2
The sound is muted for several seconds, after which the
unit operates normally.
When ever the ON/STANDBY switch is in the standby state,
the apparatus is still connected to the AC line voltage.
Please be sure to turn off the POWER switch or unplug the
cord when you leave home for, say, a vacation.
Set the volume to halfway and set the crossover frequency
to the maximum or Low pass filter off if your subwoofer can
adjust the output volume and the crossover frequency
Some subwoofers have a standby mode. Be sure to turn
this function off before performing the Auto Setup
procedure.
ENGLISH
ENGLISH
