Bedienungsanleitung Denon AVR-4800 (Seite 31 von 69) (Englisch)

584373

Zoom out

Zoom in

Vorherige Seite

1/69

Nächste Seite

REMOTE CONTROL UNIT

• The included remote control unit (RC-869) can be used to operate not only the AVR-4800 but other remote control compatible DENON

components as well. Furthermore, it is equipped with a function for learning the control signals of remote control units of other manufacturers,

so it can also be used to operate non-DENON remote control compatible video components.

Inserting the batteries

q Remove the remote control unit’s rear cover.

w Set two R6P (AA size) batteries in the battery compartment in

the indicated direction.

e Put the rear cover back on.

Notes on Batteries

• Use R6P (AA size) batteries in the remote control unit.

• The batteries should be replaced with new ones approximately

once a year, though this depends on the frequency of usage.

• Even if less than a year has passed, replace the batteries with new

ones if the set does not operate even when the remote control unit

is operated nearby the set. (The included battery is only for

verifying operation. Replace it with a new battery as soon as

possible.)

• When inserting the batteries, be sure to do so in the proper

direction, following the “<” and “>” marks in the battery

compartment.

• To prevent damage or leakage of battery fluid:

• Do not use a new battery together with an old one.

• Do not use two different types of batteries.

• Do not short-circuit, disassemble, heat or dispose of batteries in

flames.

• Remove the batteries from the remote control unit when you do

not plan to use it for an extended period of time.

• If the battery fluid should leak, carefully wipe the fluid off the inside

of the battery compartment and insert new batteries.

• When replacing the batteries, have the new batteries ready and

insert them as quickly as possible.

• The learned remote control signals may be cleared if no batteries

are in the remote control unit for about 5 seconds.

The factory-installed codes are in permanent memory, however.

Using the remote control unit

• Point the remote control unit at the remote sensor on the main unit

as shown on the diagram.

• The remote control unit can be used from a straight distance of

approximately 7 meters/22 feet from the main unit, but this

distance will be shorter if there are obstacles in the way or if the

remote control unit is not pointed directly at the remote sensor.

• The remote control unit can be operated at a horizontal angle of up

to 30 degrees with respect to the remote sensor.

NOTES:

• It may be difficult to operate the remote control unit if the remote

sensor is exposed to direct sunlight or strong artificial light.

• Do not press buttons on the main unit and remote control unit

simultaneously. Doing so may result in malfunction.

• Neon signs or other devices emitting pulse-type noise nearby may

result in malfunction, so keep the set as far away from such

devices as possible.

Approx. 7 m/22 feet

30°

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denon AVR-4800 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info