27
After setting up the system
1Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the settings again unless other
components or speakers are connected to or the speaker layout is changed.
Setting the Auto Surround Mode
For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time it the same signal
inputs, the memorized surround mode is automatically selected and the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL Default Auto Surround Mode
qAnalog and PCM 2-channel signals STEREO
w2-channel signals of Dolby Digital, DTS or other multichannel format Dolby PLIIx Cinema
eMultichannel signals of Dolby Digital, DTS or other multichannel format Dolby or DTS Surround
1Use the (left) and (right) buttons to select the Auto Surround mode.
(left) button (right) button
Press the ENTER or (down) button to switch the Ext. In SW Level setting.
(Initial)
Setting the Ext. In SW Level
Set the method of playback of the analog input signal connected to the Ext. In terminal.
1Use the (left) and (right) buttons to select the Ext. In Subwoofer channel Level playback.
(left) button (right) button
Press the ENTER or (down) button if you want to start the settings over from the beginning.
(Initial)
ENGLISH
