(Main unit)
[5] Outputting a program source to an amplifier, etc., in a different room (M-ZONE 2)
1
Press the REC/M-ZONE 2 button until
“M-ZONE 2 ✽✽✽✽” appears on the
set’s display.
Display
2
Select the source you want to record
appears on the set’s display.
• The MULTI indicator lights.
• The indicator for the selected
program source light.
• When the AVR-5803 is in the REC
OUT mode, the source cannot be
output using the M-ZONE 2 buttons
on the remote control unit.
(Main unit)
3
Start playing the source to be output.
• For operating instructions, refer to the manuals of the
respective components.
NOTES:
• The signals of the source selected in the M-ZONE-2 mode are
also output from the TAPE and VCR recording output terminals.
• Digital signals are not output from the MULTI ZONE 1 audio
output jacks.
When “M-ZONE 2” is selected for the system setup’s multi-zone
setting, the source selected here is output from the M-ZONE 2
speaker terminals.
The volume can be adjusted and the input source can be selected
using the VOLUME UP and VOLUME DOWN buttons on the remote
control unit’s “M-ZONE 2” page.
[3] Dolby Headphone recording
• When RECOUT mode is set to “source”, with the AVR-5803 it is possible to output signals encoded in the Dolby Headphone mode from
the recording output terminal and record them on a separate recorder.
1
The Dolby Headphone play mode is set when headphones are
connected to the PHONES jack during playback in the
DOLBY/DTS surround mode.
2
When this is done, signals encoded in the Dolby Headphone
mode are automatically output from the recording output
terminals (analog and digital) and can be recorded.
3
Select the parameters and set the desired mode, then record.
(Refer to the ⁄0 SURROUND “Dolby Headphone” page 60.)
