Bedienungsanleitung Denon AVR-5805CI (Seite 16 von 214) (Englisch)

584386

Zoom out

Zoom in

Vorherige Seite

1/214

Nächste Seite

Easy Setup and Operation

Speaker connections

•Connect the speaker terminals with the speakers making

sure that like polarities are matched ( <with <, >with >).

Mismatching of polarities will result in weak central sound,

unclear orientation of the various instruments, and the

sense of direction of the stereo being impaired.

NOTE:

•NEVER touch the speaker terminals when the power

is on. Doing so could result in electric shocks.

•When making connections, take care that none of the

individual conductors of the speaker cable come in

contact with adjacent terminals, with other speaker

cable conductors, or with the rear panel and screws.

Connecting the speaker cables

1. Loosen by turning

counterclockwise.

2. Insert the cable.

3. Tighten by turning clockwise.

Either tightly twist or terminate the core wires.

Connecting banana plugs

Turn clockwise to tighten, then

insert the banana plug.

Protector circuit

This unit is equipped with a high-speed protection circuit.

The purpose of this circuit is to protect the speakers under

circumstances such as when the output of the power

amplifier is inadvertently short-circuited and a large current

flows, when the temperature surrounding the unit

becomes unusually high, or when the unit is used at high

output over a long period which results in an extreme

temperature rise.

When the protection circuit is activated, the speaker output

is cut off and the power supply indicator flashes. Should

this occur, please follow these steps: be sure to switch off

the power of this unit, check whether there are any faults

with the wiring of the speaker cables or input cables, and

wait for the unit to cool down if it is very hot. Improve the

ventilation condition around the unit and switch the power

back on.

If the protection circuit is activated again even though there

are no problems with the wiring or the ventilation around

the unit, switch off the power and contact a DENON

service center.

Note on speaker impedance

The protector circuit may be activated if the set is played for

long periods of time at high volumes when speakers with

an impedance lower than the specified impedance (for

example speakers with an impedance of lower than 4

Ω/ohms) are connected. If the protector circuit is activated,

the speaker output is cut off. Turn off the set’s power, wait

for the set to cool down, improve the ventilation around the

set, then turn the power back on.

2Speaker Impedance

•Speakers with an impedance of from 6 to 16 Ω/ohms can

be connected.

Cooling fan

The AVR-5805CI is equipped with a cooling fan to prevent

the temperature inside the set from rising. The fan is

activated under certain usage conditions. It is temperature

sensitive, to minimize or prevent audible fan noise.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denon AVR-5805CI Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info