Bedienungsanleitung Denon DBP-2010CI (Seite 5 von 52) (Englisch)

584580

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Introduction Connections Playback Function Setup Others

ENGLISH

Introduction

Use only discs marked with logos listed on page 4.

The main power supply is engaged when the main plug is

plugged in a 120V, 60Hz AC outlet. To operate the unit, press

[POWER ON] or <ON/STANDBY> to turn on the unit.

To avoid fire or electric shock, do not expose this unit to rain or

moisture.

For safety and optimum performance of this unit:

• Do not stand the unit up vertically. Install the unit in a horizontal

and stable position. Do not place anything directly on top of the

unit. Do not place the unit directly on top of the TV.

• Shield it from direct sunlight and keep it away from sources of

intense heat. Avoid dusty or humid places. Avoid places with

insufficient ventilation for proper heat dissipation. Do not block

the ventilation holes on the sides of the unit. Avoid locations

subject to strong vibration or strong magnetic fields.

• Be sure to remove a disc and unplug the AC cord from the outlet

before carrying the unit.

Noise or disturbance of the picture may be generated if this unit or

any other electronic equipment using microprocessors is used

near a tuner or TV.

If this happens, take the following steps:

• Install this unit as far as possible from the tuner or TV.

• Set the antenna wires from the tuner or TV away from this unit’s

AC cord and input/output connection cords.

• Noise or disturbance tends to occur particularly when using

indoor antennas or 300Ω/ohms feeder wires. We recommend

using outdoor antennas and 75Ω/ohms coaxial cables.

●Cautions on using mobile phones.

Using a mobile phone near this unit may result in noise. If so,

move the mobile phone away from this unit when it is in use.

●Before turning the power operation button on.

Check once again that all connections are correct and that there

are no problems with the connection cables. Always set the

power operation button to the standby position before

connecting and disconnecting connection cables.

●Sufficiently ventilate the place of installation.

If the unit is left in a room full of the smoke from cigarettes, etc.,

for long periods of time, the surface of the optical pickup could

get dirty, in which case it will not be able to read the signals

properly.

Moisture condensation may occur inside the unit when it is

moved from a cold place to a warm place, or after heating a cold

room or under conditions of high humidity. Do not use the unit at

least for 2 hours until its inside is dry.

• Do not handle the AC cord with wet hands.

• Do not pull on the AC cord when disconnecting it from AC wall

outlet. Grasp it by the plug.

• If, by accident, water is spilled on this unit, unplug the AC cord

immediately and take the unit to our authorized service center

for servicing.

Pay attention to the following before using this unit:

●Moving the unit.

To prevent short-circuits or damaged wires in the connection

cables, always unplug the power supply cord and disconnect the

connection cables between all other audio components when

moving the unit.

●Store the owner’s manual in a safe place.

After reading the owner’s manual, store it in a safe place as it

could come in handy in the future.

●Whenever <ON/STANDBY> is in the STANDBY state, the unit

is still connected to AC line voltage.

Please be sure to unplug the cord when you leave home for, say,

a vacation.

●Note that the illustrations in these instructions may differ

from the actual unit for explanation purposes.

Unauthorized copying, broadcasting, public performance and

lending of discs are prohibited.

This product incorporates copyright protection technology that is

protected by U.S. patents and other intellectual property rights.

Use of this copyright protection technology must be authorized

by Macrovision, and is intended for home and other limited

viewing uses only unless otherwise authorized by Macrovision.

Reverse engineering or disassembly is prohibited.

Important

Power Supply

Warning

WARNING:

LIVE PARTS INSIDE.

DO NOT REMOVE ANY SCREWS.

Installation Location

Non-use periods - Turn off the unit when it is not in use. Unplug

the unit from the household AC outlet if it is not to be used for a

long time. Unplug the unit during lightning storms.

Please read this owner’s manual carefully before using the unit,

and keep it for future reference.

Cautions on Installation

Note

• For heat dispersal, do not install this equipment in a

confined space such as a book case or similar unit.

Cautions on Handling

ON / STANDBY

SD CARD

10 cm or more

Wall

Dew Warning

Avoid the Hazards of Electrical Shock and Fire

Before Using

About Copyright

U. S. Patent No’s, 6,836,549; 6,381,747; 7,050,698;

6,516,132 and 5,583,936.

E5KA0UD_EN.book Page 2 Tuesday, April 28, 2009 11:15 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denon DBP-2010CI Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info