14
ENGLISH
(7) Connecting the audio components (DVD-M330)
• The AVR-M330 can be used connected in a system with the DVD-M330 DVD player.
• For instructions on operating the DVD-M330 DVD player, refer to their respective operating instructions.
• Only the DVD-M330 DVD player can be connected directly to the AVR-M330 using system connections.
Connecting the speaker systems
Connect the speaker system for the left channel (the left side as seen from the
front) to the L terminals, the speaker system for the right channel to the R
terminals. Refer to the instructions supplied with the speaker system for details.
Be sure to use speaker systems with an impedance of 6 Ω/ohms or greater.
Optical cord
System cords
AC CORD
AC 230 V, 60 Hz
CAUTION:
• Only one DVD player can be connected to the AVR-M330 using system connections. System operations cannot be performed properly if
two DVD player are connected using system connections.
• Whenever the power operation switch is in the STANDBY position, the unit is still connected to AC line voltage.
• Please be sure to unplug the power cord when you leave home for, e.g.,a vacation, etc.
System operations
Such system operations as the auto power on functions, as well as remote
control operations cannot be performed unless all the RCA pin-plug cords and
system connector cords are connected between the units, so be sure to make
all the connections properly as shown in the diagram. Also, disconnecting
system connectors while the system is operating may result in malfunctions. Be
sure to unplug the power cord before changing connections.
NOTES:
• This system includes digital circuitry which may cause interference such as color blotching or changes in the color on TVs. If this happens, move the system
and the TV as far apart as possible.
• Do not plug the power cord into the power outlet until all connections are completed. Be sure to interconnect the channels (L to L (white) and R to R (red))
properly, as shown on the diagram.
• Insert the plugs securely. Incomplete connections may result in noise.
• Be sure to connect the speaker cords between the speaker terminals and the speaker systems with the same polarities ( + to +, – to – ). If the polarities are
switched, the sound at the center will be weak, the position of the different instruments will be unclear, and the stereo effect will be lost.
•After unplugging the power cord, wait about 5 seconds before plugging it back in.
• Note that setting the connection cords (pin-plug cords) next to the power cords may result in humming or other noise.
audio cord
AC CORD
AC 230 V, 50 Hz
TV
Connecting the 5.1ch speaker
AV SURROUND RECEIVER
(AVR-M330)
DVD PLAYER
(DVD-M330)
