Bedienungsanleitung Denon DN-500C (Seite 34 von 38) (Englisch)

516882

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

Troubleshooting

If a problem should arise, ﬁrst check the following:

1. Are the connections correct?

2. Is the set being operated as described in the owner’s manual?

3. Are the other devices operating properly?

If this unit does not operate properly, check the items listed in the table below. Should the problem persist,

there may be a malfunction.

In this case, disconnect the power immediately and contact your store of purchase.

GGeneralH

Symptom Cause Countermeasure Page

Disc tray does not

open/close.

•The power is not on. •Turn on the power.

The power is not

ON.

•The set is in standby mode. •Turn on the power by remote

control unit.

•Press and hold

SOURCE and

press POWER.

“TOC Error” or

“No Disc” is

displayed even

though a disc is

loaded.

•The disc is not properly loaded. •Reload the disc.

Playback does not

start even when

the

1/3 button

is pressed.

•The disc is dirty or scratched. •Wipe the dirt off the disc or

replace the disc.

No sound

is produced

or sound is

distorted.

•The output cables are not

properly connected to the

ampliﬁer.

•The ampliﬁer’s function setting

or adjustments are not right.

•Check the connections.

•Check the ampliﬁer’s functions

and controls and adjust as

necessary.

4,5,7

–

A speciﬁc section

of a disc does not

play properly.

•The disc is dirty or scratched. •Wipe the dirt off the disc or

replace the disc.

Programmed

playback is not

possible.

•The tracks have not been

programmed properly.

•Program properly.

GiPodH

Symptom Cause Countermeasure Page

The iPod cannot

be played.

•It is not properly connected to

the iPod dock.

•Reconnect.

Speciﬁcations

n CD section

Type: Single-mechanism compact disc player

Audio Channel: 2 channel stereo

Quantization: 16-bit Linear

Sampling Frequency: 44.1kHzatNormalPitch

Oversampling Ratio: 8 times

Frequency Response: 20to20,000Hz

Total Harmonic Distortion: 0.007 %

Signal-to-noise Ratio: 107 dB

Dynamic Range: 98 dB

Channel Separation: 90 dB

Analog Output: RCA jack

Output Level: 2.0Vat0dBdisc

Load Impedance: 10 kΩ or more

Digital Output: RCA jack

Signal Format: SPDIF or IEC-958 Type 11

Variable Pitch Control: ±16 % max.

Frame Search Accuracy: 1/75second

Discs: Standard compact discs (12 cm and 8 cm)

n AUX section

Stereo mini jack: UNBALANCED Jack

Reference Input Level: –16dBV

Maximum Input Level: 0dBV

Input impedance: 22 kΩ

n Headphone output Stereo

Outputs Level: 20 mW

Load Impedance: 32 Ω

n Power supply

120VAC±10%,60Hz(forUSA.&Canadamodels)

230VAC±10%,50/60Hz(forEuropean,U.K.&Asia/Pacicmodels)

Power Consumption: 15W

Installation: 19-inch rack mountable (2U)

n Environmental conditions

Operational temperature: 5 to 35°C (41 to 95°F)

Operational humidity: 25 to 85% (no condensation)Storage

Service centers are listed at http://www.d-mpro.com

For purposes of improvement, speciﬁcations and design are subject to change without notice.

Operations

InformationInformation

Preparations

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denon DN-500C Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info