Q7 Power operation switch (POWER)
Selects power “ON” or “OFF”.
NOTE:
Whenever the power switch is in the OFF state,
the AC adaptor is still connected on AC line
voltage. Please be sure to unplug the cord when
you don’t use for along time.
Q8 Balanced MASTER OUT jacks (BAL.)
• These 1/4” TRS jacks provide a balanced line
level output.
• Connect these jacks to the balanced analog
input jacks on an amplifier or console.
• Pin layout: Tip=Hot Ring=Cold Sleeve=GN
Q9 MIC BALANCED INPUT jack
• Accepts an balanced microphone with 1/4” TRS
mono jacks.
• Pin layout: Tip=Hot Ring=Cold Sleeve=GND
W0 PGM1, 2 FADER output jacks
Connect these jacks to the FADER input jacks of
DN-S3500, DN-S1200 and etc. using the 3.5mm
stereo mini cord.
W1 Phono ground screw (GND)
• This screws provide a place to connect the
ground wire from a turntable.
• This terminal is exclusively for a turntable ground
and not a safety earth ground.
W2 PHONO1, 2 / LINE1, 3 switches (LN / PH)
• These switches change the input from PHONO
to a LINE level input.
• These switches set a LINE level input when
turntable is not connected.
NOTE:
Always be sure main power is shut off before
change the position of the Line Level Selector
Switch.
W3 PHONO1, 2 / LINE1, 3 input jacks
These stereo pair of unbalanced RCA jacks are
inputs for a PHONO (RIAA) stage for magnetic
(MM) cartridges or a LINE stage suitable for any
device, such as a CD player.
W4 LINE2, 4 input jacks
These stereo pair of unbalanced RCA jacks are
inputs for any line level device.
W5 Unbalanced MASTER OUT jacks
• This stereo pair of RCA jacks provides an
unbalanced line level output.
• Connect these jacks to the unbalanced analog
input jacks on an amplifier or console.
W6 AC IN
Input connection for the included AC adaptor.
NOTE:
Use specified attached AC adaptor only.
Front panel
W7 CH 1/2 FADER START switches
Use this to switch the Channel Fader Start
function ON and OFF.
W8 CROSSFADER START A, B switches
Use this to switch the Crossader Start function
ON and OFF.
W9 CROSSFADER REVERSE switch
Reverses the direction of the crossfader.
E0 CROSSFADER CONTOUR adjustment
Adjusts the shape of the crossfader curve from
a fast cut for scratching or to a slow fade for
mixing.
E1 HEADPHONE output jack
Accept 1/4” stereo headphone plugs.
Getting Started
