Bedienungsanleitung Denon MC2000 (Seite 27 von 31) (Englisch)

614622

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

Before use

Part names and

functions

Connections

Basic

operations

Installing and setting up

supplied software

USB settings

Index Signal system chart Troubleshooting

Speciﬁcations

If a problem should arise, ﬁrst check the following:

1. Are the connections correct?

2. Is the set being operated as described in this owner’s manual?

3. Is the external device (player or effects processor) operating correctly?

If this unit does not operate properly, check the items listed in the table below.

If the symptom is not covered on the check list, contact your dealer or service centers.

Servicecentersarelistedathttp://www.d-mpro.comorhttp://www.denondj.com.

Symptom Cause/Solution Page

Power does not turn

on.

•Check that the USB cable is correctly connected to this device

and the computer.

There is no sound, or

the sound is too quiet.

•Check the connections for all devices.

•Please note that audio from the microphone input is not output

from the headphone jack.

The sound is distorted. •Adjust the master output volume adjustment knob.

•Adjust the headphone output volume adjustment knob.

•Adjust the microphone input level adjustment knob.

•Adjust the line input level adjustment knob.

This unit does not

operate properly, or

there is no sound.

•Check the connections for all devices.

•Check that the volume settings for the connected devices and

DJ software on the computer are properly adjusted.

•Match the settings on the unit to those on DJ software.

•WAV les become mixed if the sampling frequency and bit

number are different. Depending on the audio application

used,WAVlesthathavedifferentsamplingfrequenciesorbit

numbers cannot be played simultaneously.

•When other USB devices are connected to the computer,

connect only the unit to the computer and check if this works.

–

Sound cuts out or is

distorted.

•Exit any other applications.

•When multiple WAV les are played back simultaneously,

the playback sound may cut out depending on the computer

specications.Tryplayingback1WAVle.

–

Troubleshooting

n Audio

(0dBu=0.775Vrms,0dBV=1Vrms)

•LINE inputs 1 Stereo

Unbalanced RCA terminal

Input impedance: 10 kΩ

Level: 0dBV

Signal to Noise ratio: Over 82 dB

•Microphone inputs 1 Monaural

Microphone : Balanced1/4in.TRSterminal

(Tip: hot, Ring: cold, Sleeve: ground)

Input impedance: 10 kΩ

Level: –48 – –20 dBu (Unity = –40 dBu)

•USB AUDIO inputs 2Stereo(4Monaural)16bit,Fs:48kHzUSBB

•MASTER output

Unbalanced: Stereo RCA terminal

Load impedance: 10 kΩ

Level: 2.55dBV(Max+10dBV)

Frequency response: 20Hz–20kHz(±1dB)

THD: Less than 0.05 %

Crosstalk: Lessthan–85dB(1kHz)

•Headphone output Stereo1/4in.(1mm)

Load impedance: 40 Ω

Level: Over 50 mW

n General

USB MIDI input/output: IN: 1 ch, OUT: 1 ch MIDI 1.0, USB B

Channel fader: 45 mm slim type fader

Crossfader: 45 mm fader

Power supply voltage: 5V(USBBusPower)

Power consumption: 500 mA

Operating temperature: +5 °C – +35 °C

Operating humidity: 25 % – 85% (no condensation)

Storage temperature: –20 °C – +60 °C

z For the purpose of improvement, the speciﬁcations and design are subject to change without notice.

Speciﬁcations

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denon MC2000 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Denon MC2000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info