18668
39
Zoom out
Zoom in
Vorherige Seite
1/148
Nächste Seite
36
ENGLISH
Basic Operation Basic Operation
ENGLISH
4
Press the CURSOR
,
ª
,
00
or
11
button to set
the current time, then press the ENTER button.
5
Press the ENTER button to enter the setting.
•To check the current time when the regular display is displayed,
press the STATUS button once.
The time can be displayed by pressing the STATUS button when
the power is in the standby mode. (When this is done, the set
is no longer in the low power consumption standby mode.)
When pressed twice while the time is displayed, the display
turns off and the set is put back in the low power consumption
standby mode ( page 59).
The clock runs by synchronizing with the power supply
frequency. The time may be off by 2 to 3 minutes per month. If
so, reset the time.
3
Press the ENTER button twice to change the
current time.
Example: When the current time is set to “PM 7:30”
Setting the sleep timer
The included remote control unit can be used to turn the power
to the standby mode after a maximum of 120 minutes. (Sleep
timer)
Use this function to automatically switch the power to the
standby mode after a specific amount of time (minutes).
Example: To set the power to the standby mode in 50 minutes
according to the clock.
1
Select and play the desired function.
2
Press the SLEEP button.
“120” is displayed and the “SLEEP” indicator flashes.
120
The display switches as follows each time the SLEEP button
is pressed:
90120 60 50 3040 20 10
“SLEEP” indicator off
3
When the “SLEEP” indicator is flashing, press
the SLEEP button again until “50” is displayed.
“50” is displayed and the “SLEEP” indicator flashes.
50
After 4 seconds, the display returns to as it was before the
sleep timer was set, and the “SLEEP” indicator stops
flashing, remaining lit. (This completes the sleep timer
setting.)
4
The power is set to the standby mode 50 minutes
later.
To turn the sleep timer off, press the SLEEP button
repeatedly until the “SLEEP” indicator turns off. The sleep
timer can also be turned off by press the ON/STANDBY
switch on the main unit or the remote control unit to turn the
entire system’s power to the standby mode.
If the SLEEP button is pressed while the sleep timer is
operating, the setting returns to 120 minutes. Make the setting
over.
If the sleep timer and everyday timer settings overlap, the sleep
timer has priority.
8:00p.m. 9:00p.m. 10:00p.m.
8:00p.m. 9:00p.m. 10:00p.m.
ON OFF
ON OFF
+
ON OFF
8:00p.m. 9:00p.m. 10:00p.m.
ON OFF
ON OFF
+
Also, the everyday timer will not operate if its start time is set
within the time during which the sleep timer is operating.
Everyday timer
once timer setting
Sleep timer
setting
Timer operation
If the timers overlap like this, the timer operates as follows:
Everyday timer
once timer setting
Sleep timer
setting
Does not operate
Does not operate
The remaining time of the sleep timer can be checked with
the STATUS button.
39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Denon S301 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info