820560
71
Zoom out
Zoom in
Vorherige Seite
1/109
Nächste Seite
68/106
wind force, type of road, constant
braking).
3) Frequent coasting or headwinds as
well as poor roads
4) the tire pressure is not high enough
(inflate them)
5) frequent stops and restarts
6) The battery has been stored without
recharging for a long time.
3) this is a normal cause and the
problem will be solved with improved
conditions
4) inflate the tires to a pressure of 3.1
bar
5) the problem will be solved with the
improvement of the usage conditions
6) regularly recharge the battery in
accordance with the instruction
manual. If this does not solve the
problem, contact your dealer or a
qualified professional.
After connecting the charger, the
charging LEDs do not light up.
1) problem with the electrical outlet
2) faulty contact between the charger
input socket and the electrical outlet
3) the temperature is too low
1) check and repair the electrical outlet
2) check and fully insert the socket
3) charge indoors
If the previous solutions don’t work
contact your dealer or a qualified
professional.
After recharging for more than 4/5
hours, the charge indication LED is still
red
(note: it is very important to recharge
the battery according to the
instructions to avoid damaging the
equipment).
1) the ambient temperature is 40°C or
higher
2) the ambient temperature is 0 ° C or
less
3) The bicycle was not recharged after
use which exacerbated the decrease in
charge
4) The output voltage is too low to
recharge the battery.
1) recharge the battery at a
temperature below 40°C and in
accordance with the instructions
2) recharge the battery indoors and in
accordance with the instructions
3) correctly maintain the battery to
avoid an exacerbating the decrease in
charge
4) Do not recharge with a voltage lower
than 100 V.
If the previous solutions don’t work
contact your dealer or a qualified
professional.
LCD display:
The speed is not displayed on the LCD
monitor.
The magnetic ball on the wheel radius is
too far from the sensor (attached to the
rear of the frame or the front fork)
which prevents the sensor from
Check the distance between the
magnetic ball and the sensor and make
sure it does not exceed 5 mm.
71

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Denver Carratt E-4400 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info