Note:
You must make the time and alarm time adjustments while the display is flashing.
The display will stop flashing after approximately 10 seconds if adjustments are
not made.
If two alarms are set together, for example alarm1 set to buzzer alarm and alarm2
set to radio alarm, when buzzer is activated by alarm1 and radio is activated by
alarm2, the previous alarm does not stop automatically and has both buzzer and
radio sound together.
RADIO OPERATION
General Operations
1. Press the “ON/OFF/NAP” button (2) to turn radio on and off.
2. For manual tuning, press “HOUR / TUNING –“ button (5) or “MIN / TUNING
+“ button (9) for increments of 0.1mHz.
3. For automatic tuning, press and hold down “HOUR / TUNING –“ button (5) or
“MIN / TUNING +“ button (9) for approximately 3 seconds. Release the button
and the radio will start to scan for the next available station.
4. Press “ALARM1 / VOL –“ button (4) or “ALARM2 / VOL +“button (8) to adjust
volume level. The display changes to show the volume level indication (00 to 14)
during the volume adjustments, then changes back to the radio station frequency
and then the current time.
5. Press “HOUR / TUNING –“ button (5) or “MIN / TUNING +“ button (9) to show the
radio station frequency.
Pre-set Station Memory
1. The radio can store up to 20 FM stations.
2. To store a station in memory, tune to the desired radio station. Press and hold
down “TIME/PRESET” button (6) for approximately 3 seconds and “P01” on the
display will flash. Press “P+” button (7) or “P-“ button (3) to the desired station
memory (P01 to P20). Press “TIME/PRESET” button (6) once to confirm.
3. Repeat the above steps for up to 20 stations.
4. To recall the station, press “P+” button (7) or “P-“ button (3) until desired station
is reached.
Sleep mode
1. When the radio is on, press “SNOOZE / SLEEP / DIM” button (1) to enter sleep
mode. “OFF” will be displayed. Press “SNOOZE / SLEEP / DIM” button (1)
