PREPARATION OR USE
This clock radio includes a battery backup system that will maintain the time and
alarm settings during a temporary power interruption. Insert two ‘AAA’ size batteries
correctly by matching the polarity (+/-) markings in the battery compartment (10). If
you experience a power failure while batteries are installed, the display will turn ‘off’
but the clock will continue to run and maintain your alarm settings. Please replace all
batteries at the same time with only new batteries.
The clock radio has slip proof silicon feet. Place the clock radio only on protected
furniture.
Plug AC plug (12) into 230vac electrical outlet.
Unwind the FM antenna (9) on the back of the clock radio. Extend and reposition the
antenna for best radio reception.
Note: The time and alarm times can only be set when the radio is turned off.
ALARM CLOCK OPERATION
SETTING THE TIME
1. Press and hold down “MEM / TIME” button (2) for approximately 3 seconds until
the display flashes.
2. Press “TUN - / HOUR” button (5) repeatedly to change the hour setting.
3. Press “TUN + / MIN” button (6) repeatedly to change the minute setting.
4. Press “MEM / TIME” button (2) to confirm at the time and the display will stop
flashing.
SETTING THE ALARM TIME
This clock radio has dual alarms that can be set and used independently. The
procedure to set both alarms are the same. Both alarms can either sound the buzzer
or wake up to radio.
1. Press “VOL – / AL1” button (3) for setting alarm time 1 and indicator (B) will flash.
2. Press “VOL – / AL1” button (3) again for setting alarm buzzer 1 and indicator (C)
will flash.
3. When the digits are flashing, press “TUN - / HOUR” button (5) repeatedly to
change the hour setting. Press “TUN + / MIN” button (6) repeatedly to change the
minute setting.
4. Press “VOL – / AL1” button (3) to confirm.
