Bedienungsanleitung Denver MCU-5301 (Seite 12 von 24) (Deutsch, Englisch)

499212

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

E-11

3. Slide the FUNCTION SELECTOR to “RADIO” and the BAND SELECTOR to AM, FM or FM ST as

desired.

4. Tune to your desired station, and adjust the volume level that you wish to hear when the wake up time is

reached then press the POWER BUTTON again to turn off the System. Reconfirm the wake up time

setting by tapping the AL SET BUTTON.

5. At the selected wake up time the radio will turn 'On' and remain ‘On’ until it is turned off.

6. If you do not want the alarm to turn the radio on the following day, press the AL.ON/OFF Button again to

turn off the alarm function. The ALARM INDICATOR,

, goes off.

WAKE TO CD

1. Press the POWER BUTTON to turn on the System. The LCD DISPLAY lights up.

2. Press the AL.ON/OFF Button once to turn on the alarm function. The ALARM INDICATOR will light up.

3. Slide the FUNCTION SELECTOR to “CD” to start playback.

4. Adjust the volume level that you wish to hear when the wake up time is reached then press the POWER

BUTTON again to turn off the System.

5. At the selected wake up time the radio will turn 'On' and remain ‘On’ until it is turned off.

6. If you do not want the alarm to turn the System on the following day, press the AL.ON/OFF Button again

to turn off the alarm function. The ALARM INDICATOR,

, goes off.

WAKE TO ALARM

1. Set the FUNCTION SELECTOR to the “ALARM” position.

2. At the selected wake up time the alarm will sound for 3 minutes and turn off automatically.

3. If you do not want the alarm to turn on the following day, press the AL.ON/OFF Button again to turn off

the alarm function. The ALARM INDICATOR,

, will go off.

CARE AND MAINTENANCE

1. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.

2. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.

3. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps

or motors.

4. If drop-outs or interruptions occur in the music during CD play, or if the CD

fails to play at all, its bottom surface may require cleaning. Before playing,

wipe the disc from the center outwards with a good soft cleaning cloth.

TROUBLESHOOTING GUIDE

If you experience difficulties in the use of this music system please check the following or call

1 800 777 5331 for Customer Service and Support.

Symptom Possible Cause Solution

Noise or sound distorted

on AM or FM broadcast

- Station not tuned properly for AM or

FM.

- FM: FM Wire antenna is not

extended.

- AM: The bar antenna is not positioned

correctly

- Retune the AM or FM broadcast

station.

- FM: Extend the FM Wire antenna.

- AM: Reposition the unit until the best

reception is obtained.

AM or FM no sound - Unit not in “RADIO” function mode.

- Volume set at minimum

- Slide FUNCTION SELECTOR to

“RADIO” position.

- Increase Volume.

CD player will not play - Unit not in CD function mode.

- CD is not loaded properly.

- If the CD is self-compiled, the media

used may not be compatible with the

player.

- Select CD function mode.

- Load CD with label side up.

- Use better quality blank media and

retest.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Denver MCU-5301 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info