4
SETUP
Positioning the Retro Turntable
Where will your Retro Turntable and speakers be situated? If you place the Retro
Turntable on the same surface and very close to the speakers, the sound quality can
be affected by the airborne movements coming from the speakers and from any
vibrations from the surface on which they have been placed.
If at all possible, it is recommended that you leave a space of approximately 40cm
between each speaker. The Retro Turntable and the surface on which you have
placed the Retro Turntable and speakers, does not suffer from too much vibration,
which can then be transmitted up into the Retro Turntable. Please make sure that:
• The Retro Turntable and speakers are on a flat and stable surface, which does
not suffer from too much vibration. If you can, place the speakers on a different
surface to the Retro Turntable.
• It is at least 1 meter away from other electrical appliances to avoid interference.
• It is within 1.4 meters of a power socket. Please ensure that the mains power lead
and speaker wires are not a trip hazard.
• It is where it will be in range of the connected or 'paired' bluetooth devices (e.g.
iPod/ iPhone/iPad/ Android/other phone/Computer), which is about 10 meters or
fewer (33 feet or less) in line of sight.
• You do not place your Retro Turntable or speakers directly onto antique or
polished surfaces..
Setting up
1. Remove any product packaging materials, including any tape or foam that have
been used to protect the product during transportation.
2. Connect the speakers to the Left and Right speaker sockets on the back of the
Retro Turntable. Please note that the speaker cable with the red RCA plug should
be connected to the red RCA socket and the speaker cable with the white RCA
plug should be connected to the white RCA socket.
3. Fully extend the wire radio aerial on the back of the Retro Turntable to receive the
best possible FM radio with sound quality.
4. Plug the mains power into the mains power wall socket and switch on. Your Retro
Turntable will now be in Standby mode.
5. We recommend that you now set the clock.
