Bedienungsanleitung Derby Cycle Pedelec Xion 2013 (Seite 49 von 259) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

658408

Zoom out

Zoom in

Vorherige Seite

1/259

Nächste Seite

16 VIII User Manual Pedelec Xion

5.2.3 Battery charge state indicator

The battery charge state indicator is located to the right of

the centre of the display. Using a stylised battery divided

into four segments, it shows the charge remaining in the

battery. The lower the charge state of the battery is, the

fewer segments are displayed.

If the battery charge state falls below a minimum level,

the assistance switches o via the motor. The display

remains active until the battery reaches the lowest pos-

sible charge state.

If you do not move your Pedelec for 10 minutes, the sys-

tem switches o automatically. If you subsequently want

to ride using the assistance, you will have to switch it

back on using the diamond button.

5.2.4 Remaining range indicator

To the right of the display of the power-assist mode, the

distance inkm over which you can still travel with power

assist is displayed. This is the remaining range indicator.

This “remaining range” is calculated using two meas-

urements taken during the current journey. One short

and one long measurement give a representative av-

erage value. If the conditions of the journey change,

for example, by riding up an incline aer a long, at

stretch, the value displayed can also change at short

notice. Please consider this factor when planning your

trips. You are probably familiar with this eect om

the remaining range indicator of your car.

Charge state indicator

1 Battery ll

2 Battery almost empty

5.2.5 Pushing assistance

First of all, pushing assistance must be activated in

programming mode (➠ Chapter 5.4.4 “Pushing assis-

tance”).

To activate the pushing assistance, press and hold the

upper arrow button. To receive no rther pushing assis-

tance, release the button.

5.3 Troubleshooting

If your bike has been exposed to wet conditions for

an extended period, e.g. aer a trip in heavy rain, or

if there have been large dierences in temperature,

the screen of the display may steam up. This mois-

ture does not impair the nction of the display. It is

comparable with the steam on a pair of glasses when

you enter a warmer room having been outside. Aer

a short time in drier and warmer conditions, this con-

densation will vanish leaving no trace.

Error messages do not appear on the entire screen, but

rather in place of the battery display on the right-hand

side. All symbols remain permanently visible, with the

exception of the “Inspection due” symbol.

SYMBOL CAUSE SOLUTION

Battery almost

empty.

• Recharge your

battery.

Inspection due. • Consult your spe-

cialist cycle shop.

Temperature is

too high. The

motor is too hot.

• Allow your system

to cool down.

A fault has

occurred in the

system.

• Please contact

your specialist

cycle shop.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Derby Cycle Pedelec Xion 2013 Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info