Bedienungsanleitung DeWalt DC 228 (Seite 41 von 204) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

79260

Zoom out

Zoom in

Vorherige Seite

1/204

Nächste Seite

ENGLISH

WARNING: Shock hazard. Do not allow

any liquid to get inside charger. Electric

shock may result.

CAUTION: Burn hazard. To reduce

the risk of injury, charge only D

EWALT

rechargeable batteries. Other types of

batteries may burst causing personal

injury and damage.

CAUTION: Under certain conditions,

with the charger plugged in to the power

supply, the exposed charging contacts

inside the charger can be shorted by

foreign material. Foreign materials of

a conductive nature such as, but not

limited to, steel wool, aluminum foil, or

any buildup of metallic particles should

be kept away from charger cavities.

Always unplug the charger from the

power supply when there is no battery

pack in the cavity. Unplug charger before

attempting to clean.

• DO NOT attempt to charge the battery pack

with any chargers other than the ones in

this manual. The charger and battery pack are

specifically designed to work together.

• These chargers are not intended for any uses

other than charging D

EWALT rechargeable

batteries. Any other uses may result in risk of

fire, electric shock or electrocution.

• Do not expose charger to rain or snow.

• Pull by plug rather than cord when

disconnecting charger. This will reduce risk

of damage to electric plug and cord.

• Make sure that cord is located so that it will

not be stepped on, tripped over, or otherwise

subjected to damage or stress.

• Do not use an extension cord unless it

is absolutely necessary. Use of improper

extension cord could result in risk of fire,

electric shock, or electrocution.

• Do not place any object on top of charger

or place the charger on a soft surface that

might block the ventilation slots and result in

excessive internal heat. Place the charger in a

position away from any heat source. The charger

is ventilated through slots in the top and the

bottom of the housing.

• Do not operate charger with damaged cord

or plug — have them replaced immediately.

• Do not operate charger if it has received

a sharp blow, been dropped, or otherwise

damaged in any way. Take it to an authorised

service center.

• Do not disassemble charger; take it to an

authorized service center when service or

repair is required. Incorrect reassembly may

result in a risk of electric shock, electrocution or

fire.

• Disconnect the charger from the outlet before

attempting any cleaning. This will reduce the

risk of electric shock. Removing the battery

pack will not reduce this risk.

• NEVER attempt to connect 2 chargers together.

• The charger is designed to operate on

standard 230V household electrical power.

Do not attempt to use it on any other voltage.

This does not apply to the vehicular charger.

SAVE THESE INSTRUCTIONS

Transporting

D E WALT Li-Ion battery packs comply with the

necessary testing requirements under the UN

Manual of Tests and Criteria (ST/SG/AC.10/11/

Rev.3 Part III, Subsection 38.3) as referenced in

the UN Recommendations on the Transport of

Dangerous Goods.

- The battery packs have effective protection

against internal overpressure and short-

ciruiting.

- Appropriate measures have been provided for

prevention of forced rupture and dangerous

reverse current.

- The equivalent lithium content is below the

relevant limit value.

D E WALT Li-Ion battery packs are exempted from

national and international regulations applicable

to dangerous goods. However, these regulations

become relevant when transporting several battery

packs together.

• Make sure that battery packs are packed

according to the dangerous goods regulations

as mentioned above to prevent short-circuiting.

Chargers

The DE9000 charger accepts 28 V and 36 V Li-Ion

batteries.

This charger requires no adjustment and is designed

to be as easy as possible to operate.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeWalt DC 228 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DeWalt DC 228

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info