Bedienungsanleitung DeWalt DCH273 (Seite 11 von 60) (Englisch, Französisch, Spanisch)

712258

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

English

there is no battery pack in the cavity. Unplug the charger before

attempting toclean.

7. Do not freeze or immerse the charger in water or any otherliquid.

WARNING: Shock hazard. Don’t allow any liquid to get inside the

charger. Electric shock mayresult.

WARNING: Burn hazard. Do not submerge the battery pack in any

liquid or allow any liquid to enter the battery pack. Never attempt to

open the battery pack for any reason. If the plastic housing of the

battery pack breaks or cracks, return to a service center forrecycling.

Storage Recommendations

1. The best storage place is one that is cool and dry, away from direct

sunlight and excess heat orcold.

2. For long storage, it is recommended to store a fully charged battery

pack in a cool dry place out of the charger for optimalresults.

NOTE: Battery packs should not be stored completely depleted of

charge. The battery pack will need to be recharged beforeuse.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

COMPONENTS (Fig. 2)

WARNING: Never modify the power tool or any part of it. Damage

or personal injury couldresult.

A. Side handle

B. Trigger switch

C. Forward/reverse control

button (Lock-off button)

D. Mode selector

E. Main handle

F. Worklight

G. Battery pack

H. Battery release button

I. SHOCKS - Active Vibration

control

J. Utility hook

and 75 °F (18 ° – 24 °C). DO NOT charge the battery pack in

an airtemperature below +40 °F (+4.5 °C), or above +104 °F

(+40°C). This is important and will prevent serious damage to the

batterypack.

2. The charger and battery pack may become warm to the touch

while charging. This is a normal condition, and does not indicate

a problem. To facilitate the cooling of the battery pack after use,

avoid placing the charger or battery pack in a warm environment

such as in a metal shed or an uninsulatedtrailer.

3. A cold battery pack will charge at about half the rate of a warm

battery pack. The battery pack will charge at that slower rate

throughout the entire charging cycle and will not return to

maximum charge rate even if the battery packwarms.

4. If the battery pack does not charge properly:

a. Check operation of receptacle by plugging in a lamp or other

appliance;

b. Check to see if receptacle is connected to a light switch which

turns power off when you turn out the lights;

c. Move the charger and battery pack to a location where the

surrounding air temperature is approximately 65 °F – 75 °F

(18° – 24 °C);

d. If charging problems persist, take the tool, battery pack and

charger to your local servicecenter.

5. The battery pack should be recharged when it fails to produce

sufficient power on jobs which were easily done previously. DO

NOT CONTINUE to use under these conditions. Follow the

charging procedure. You may also charge a partially used pack

whenever you desire with no adverse effect on the batterypack.

6. Foreign materials of a conductive nature such as, but not limited

to, grinding dust, metal chips, steel wool, aluminum foil, or any

buildup of metallic particles should be kept away from charger

cavities. Always unplug the charger from the power supply when

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeWalt DCH273 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info