Bedienungsanleitung DeWalt DW055E (Seite 4 von 8) (Englisch)

790849

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Under Industry Canada regulations, the radio

transmitter(s) in this device may only operate using

an antenna of a type and maximum (or lesser) gain

approved for the transmitter by Industry Canada. To

reduce potential radio interference to other users, the

antenna type and its gain should be so chosen that the

equivalent isotropically radiated power (e.i.r.p.) is not

more than that necessary for successful communication.

DeWalt, Slough, Bershire SL1 3YD, UK herewith

declares that the product DW033 / DW055E is in

compliance with the essential requirements and all

other provisions of Directive 1999/S/EC. Please contact

DeWalt for DoC.

Battery Safety

WARNING: Batteries. can explode or leak and

can cause injury or re. To reduce the risk:

ALWAYS follow all instructions and warnings

on the battery label and package.

DO NOT short any battery terminals.

DO NOT charge alkaline batteries.

DO NOT mix old and new batteries. Replace

all of them at the same time with new

batteries of the same brand and type.

DO NOT mix battery chemistries.

DO NOT dispose of batteries in re.

ALWAYS keep batteries out of reach of

children.

ALWAYS remove batteries if the device will

not be used for several months.

NOTE: Ensure that the recommended

batteries are used.

NOTE: Ensure the batteries are inserted in the

correct manner, with the correct polarity.

Setup (Load Batteries)

1. Locate the battery compartment latch on the back

of the tool (Figure B #2).

2. Using your finger, pull the latch down to unlock

and remove the battery door (Figure C #1).

3. Insert two AAA batteries, making sure to position

the - and + ends of each battery as noted inside

the battery compartment (Figure C #2).

4. Slide the pins at the bottom of the battery door

into the notches in the battery compartment (Figure

C #3), and push the door down until it snaps into

place.

When the tool is ON, the battery level appears in the

display window (Figure E #1).

Operation

1. Point the laser at the top of the tool (Figure A

#1) toward the wall whose distance you need to

measure (Figure D #1).

2. Click (Figure A #3) to display a laser dot on the

wall (Figure D #1) and measure the distance from

the bottom of the tool to the wall (Figure D #2).

3. At the bottom of the display window (Figure A

#2), view the current measurement (Figure E #3),

which will keep changing as you move the tool (in

Continuous Measure mode).

4. When the bottom of the tool is positioned at the

correct distance from the wall, click to take

the current measurement on the display window

(Figure E #3).

Changing the Unit of Measure

Once the current measurement is taken, you can

change the unit of measure from decimal ft (6.21 ft) to

fractional ft (6'02"9/16), fractional ft to meters (1.894

m), meters to inches (74 9/16 in), or inches to decimal ft.

To change the unit of measurement, press and hold

until you see the measurement change (2-3 seconds).

NOTE: If you continue to hold after the

measurement changes, the tool will turn off.

Re-measuring

If you need to take a new measurement, click .

• The previous measurement (Figure E #2) will appear

above the new current measurement (Figure E #3).

• When you are ready to take the new current

measurement, click .

Turning Off the Tool

The tool can be turned off in either of these ways:

• Press and hold for 4 seconds (until the display

window clears).

• If you do not use the tool for 180 seconds, it will

automatically turn off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeWalt DW055E Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info