Bedienungsanleitung DeWalt DW055PL (Seite 4 von 20) (Englisch, Französisch, Portugiesisch, Spanisch)

790850

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

FCC Statement

These devices comply with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions: 1) this device may not cause

harmful interference, and 2) this device must

accept any interference received, including

interference that may cause undesired

operation.

NOTE: This equipment has been tested and

found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can

radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is

no guarantee that interference will not occur

in a particular installation. If this equipment

does cause harmful interference to radio and

television reception, which can be determined

by turning the equipment off and on, the user

is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet

on a circuit different from that which the

receiver is connected.

• Consult the dealer or an experienced radio/

TV technician for help.

Canada, Industry Canada (IC) Notices

Class B digital circuitry of this device complies

with Canadian ICES-003. This device complies

with Industry Canada license-exempt RSS

standard(s). Operation is subject to the

following two conditions: 1) this device may

not cause interference, and 2) this device must

accept any interference, including interference

that may cause undesired operation of the

device.

Charging the Battery

Fully charge the battery before initial use and

whenever the tool has not been used for 6

months or longer.

WARNING:

Only charge product using

a certied power adapter that is

compliant with applicable country

regulations and international/regional

safety standards. Using adapters

that do not meet applicable safety

standards could result in injury.

1. Locate the port cover on the bottom of the

tool (Figure A 4).

2. Using your finger, gently pull the port cover

up (Figure C 1).

3. Insert the small end of the USB Recharge

Cable into the port on the bottom of the

tool, making sure to insert the flat side

of the cable into the flat side of the port

(Figure C 2).

4. Insert the USB end of the cable into a USB

port in a computer or USB power outlet

(Figure C 3).

5. Wait approximately 2.5 hours for the

battery to fully charge and then disconnect

the USB Recharge Cable.

When the tool is ON, the battery level appears

in the display window (Figure D 1).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DeWalt DW055PL Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info