Bedienungsanleitung Dik Geurts Prostyle 800V (Seite 32 von 112) (Deutsch, Englisch, Holländisch, Französisch)

695348

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

English

INSTALLATION MANUAL

Any existing chimney must be clear of obstruction and have been swept clean immediately before installation of

the stove. If the stove is fitted in place of an open fire then the chimney should be swept one month after

installation to clear any soot falls which may have occurred due to the difference in combustion between the

stove and the open fire. If there is no existing chimney then any new system must be to the designation described

above and in accordance with Building Regulations Approved Document J.A single wall metal fluepipe is suitable

for connecting the stove to the chimney but is not suitable for use as the complete chimney. The chimney and

connecting fluepipe must have a minimum diameter and its dimension should be not less than the size of the

outlet socket of the stove (see Annex 1, table 2).

Any bend in the chimney or connecting fluepipe should not exceed 45°. 90° bends should not be used.

Combustible material should not be located where the heat dissipating through the walls of fireplaces or flues

could ignite it. Therefore when installing the stove in the presence of combustible materials due account must be

taken of the guidance on the separation of combustible material given in Building Regulations Approved

Document J and also in these stove instructions.

If it is found that there is excessive draught in the chimney then a draught stabiliser should be fitted. Fitting of a

draught stabiliser will affect the requirement for the permanent air supply into the room in which the stove is

fitted in accordance with Approved Document J (see also combustion air supply).

Commissioning and handover

Ensure all parts are fitted in accordance with the instructions.

On completion of the installation allow a suitable period of time for any fire cement and mortar to dry out, before

lighting the stove. Once the stove is under fire check all seals for soundness and check that the flue is functioning

correctly and that all products of combustion are vented safely to atmosphere via the chimney terminal. On

completion of the installation and commissioning ensure that the operating instructions for the stove are left with

the customer. Ensure to advise the customer on the correct use of the appliance and warn them to use only the

recommended fuel for the stove.

Advise the user what to do should smoke or fumes be emitted from the stove. The customer should be warned to

use a fireguard to BS 8423:2002 (Replaces BS 6539) in the presence of children, aged and/or infirm persons.

Warning note on fume emission

Properly installed, operated and maintained this appliance will not emit fumes into the dwelling.

Occasional fumes from de-ashing and re-fuelling may occur. However, persistent fume emission is potentially

dangerous and must not be tolerated. If fume emission does persist, the following immediate actions should be

taken:

a) Open doors and windows to ventilate room.

b) Let the fire out or eject and safely dispose of fuel from the appliance.

c) Check for flue or chimney blockage, and clean if required.

Do not attempt to relight the fire until the cause of the fume emission has been identified and corrected. If

necessary seek expert advice.

Extractor fan

There must not be an extractor fan fitted in the same room as the stove as this can cause the stove to emit smoke

and fumes into the room.

Permanent air vent

The stove requires a permanent and adequate air supply in order for it to operate safely and efficiently.

In accordance with current Building Regulations the installer may have fitted a permanent air supply vent into the

room in which the stove is installed to provide combustion air. This air vent should not under any circumstances

be shut off or sealed.

Chimney cleaning

The chimney should be swept at least twice a year. It is important that the flue connection and chimney are swept

prior to lighting up after a prolonged shutdown period. If the stove is fitted in place of an open fire then the

chimney will require sweeping after a month of continuous operation. This is a precaution to ensure that any

“softer” deposits left from the open fire usage have not been loosened by the higher flue temperatures generated

by the closed stove.

Periods of Prolonged Non-Use

If the stove is to be left unused for a prolonged period of time then it should be given a thorough clean to remove

ash and unburned fuel residues. To enable a good flow of air through the appliance to reduce condensation and

subsequent damage, leave the air controls fully open.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dik Geurts Prostyle 800V Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dik Geurts Prostyle 800V

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info