706523
23
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
Always ensure that the re is sitting on a level oor.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and
dry the sump.
Once installed, never move this re or lay on its back, without draining the water from sump and water tank.
The water tank, sump, sump lid, tank cap and air lters must be cleaned once every two weeks, particularly in
hard water areas.
The re appliance should never be operated if the lamps are not working.
The lamps should be regularly inspected as described under ‘Maintenance’ and ‘Changing lamps’.
Ensure that all packing items are removed (read any warning labels carefully).
Retain all packing for possible future use, in the event of moving or returning the appliance to your supplier.
To reduce heat losses and to prevent any chimney updraught affecting the operation of your re we
recommend that the chimney ue is blocked off, ensure that there is a slight gap for ventilation.
To install the appliance;
Hold the re by the sides and gently manoeuvre into position. Plug the re into a 13amp/240 volt outlet. Ensure that
the supply cable exits at the front of the re, at the right or left hand corner to suit your supply socket location and is
not trapped under the re such that it might cause it to be damaged.
Before switching on the appliance, please read the following instructions.
Before using the manual controls rstly ll the water tank (See ‘Maintenance’, ‘Filling the water tank’).
Manual Controls.
The manual controls are located behind the drawer.
(See Fig.2 for Manual Control lay out)
Switch ‘A’:- Controls the electricity supply to the re.
Note: This switch must be in the ‘ON’ ( I ) position for the re to operate
Switch ‘B’:- Controls the function of the re.
Press once to turn on ame effect. This will be indicated by one beep.
Although the main lights operate immediately it will take a further 30 seconds before the ame effect starts.
Press to put re in to standby mode.
This will be indicated by one beep.
Control Knob ‘C’:- Controls the intensity of the ame effect.
Turning the control knob up increases the ame effect, turning the control knob down will decrease the ame
effect.
When the water tank is empty the main lamps go out. See instructions under ‘Maintenance’, ‘Filling the water tank’.
When this procedure is complete, the main lamps will illuminate but it will take 30 seconds before the ames return.
Remote Control Operation
On the control panel, Switch A (see Fig.2) must be in the ‘ON’ ( I ) position in order for the remote control to operate.
There are 2 buttons on the remote control. (See Fig.7)
To operate correctly the remote must be pointed towards the front fuel effect.
The remote control functions are as follows:
Press once to turn on Flame effect only.
This will be indicated by one beep.
Standby
This will be indicated by one beep.
Battery Information.
1. Unclip the battery cover on the back of the remote control. (See Fig.7)
2. Install AAA batteries into the remote control.
3. Replace the battery cover.
Discard leaky batteries.
Dispose of batteries in the proper manner according to provincial and local regulations.
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all the batteries are
not replaced at the same time, if disposed of in a re, or if an attempt is made to charge a battery not intended to be
recharged.
Tips for using your appliance.
1. Only pull out the drawer when its time to re ll the water tank or change a lamp, otherwise it may lead to excess water
in the sump and reduced ame effect. If this happens empty the water from the sump as instructed under ‘Maintenance’.
2. With the ame setting on minimum the unit will use approximately 40ml of water per hour and will last 3 times as long
than when it is at maximum ame setting.
3. Do not tilt or move the re while there is water in the tank or sump.
Installation Instruction
17
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Dimplex Cassette L wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info