2. Clean the air filter
If the air filter is blocked with a lot of dust, the
efficiency will be reduced. You should clean the
filter every two weeks.
1) Pull out the air filter as Fig.14.
2) Wash the air filter by immersing it gently in
warm (under 40°C or 104°F) water with neutral
detergent. Rinse the filter and dry it in a shaded
place.
3) Push the air filter back into the original
position.
End Of Season
1.Pull out the plug from the drain mouth and remove the water from the drain pan. You can remove
the water entirely by slanting the unit back.
Setting the fan mode, then press the Fan button for 5 seconds until the lower fan works. After that,
operate the unit in fan mode for half a day until the pipe is dry. In this way the inside of the unit can
be dried.
2.Switch off the unit and disconnect the plug from the power supply.
3.Tie the cable with string.
4.Remove the air exhaust duct and keep stored in a safe dry place.
5.Wrap the unit with the plastic bag, and keep it in a dry place.
6.Take the batteries out of the remote control and keep in a dry place.
Trouble Shooting
Before contacting a professional please read the following troubleshooting guide .
Trouble Check Solution
The unit doesn’t
operate at all.
Is power fail?
Is plug out?
Is power fuse or switch off?
Is the set time suitable?
Is water full alarm on?
It is normal.
Insert the plug into the socket
steadily.
Change the fuse or switch on.
Change the set time.
Empty the internal water reservoir
Cooling efficiency is
not good
Is air inlet or outlet blocked?
Is there any other heat source in
room?
Are air filters very dirty?
Is the set temperature suitable?
Is fan speed set at low?
Clear the blockages
Move the heat source.
Clean the air filter.
Change temperature.
Select suitable fan speed.
