Bedienungsanleitung Dimplex EF12-20TID (Seite 10 von 28) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

798179

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

EN-10 EF12_20_gb · 12/14/B www.dimplex.de/en

English

EF 12/20, EF 12/20 TI, EF 12/20 TID, EF 12/10

5.3 EF 12/20 TID - Models with 24-hour timer

The operating hours of the heater can be set in a day

program (24 hours) using the timer.

For automatic operation, slide the switch (C) to the right

into "clock" position.

Setting the time:

Turn timer (D) clockwise until the marking matches up

to the current time.

Heater ON: Slide segments outwards.

Heater OFF: Slide segments inwards.

Each segment represents a switch-on or switch-off

time of 20 minutes. In order, for example, to set a

switch-on time of one hour, 3 segments are slid out-

wards.

The timer can be pro-

grammed for several ON/

OFF phases of different

lengths. The thermostat

provides a uniform room

temperature during the

switch-on time.

Outside of the switching

time, no heating opera-

tion - and thus no frost

protection - takes place.

Operation via the timer can be deactivated at any time

by switching to "Manual" or "0" (OFF).

The timer only runs when the device is connected to

the power supply.

6. Protection Against Overheating

If the permissible temperature is exceeded, the heater

switches off automatically. If this occurs, pull the mains

plug out and leave the device unplugged for a few min-

utes, so that the temperature limiter can switch back

again.

Then remove the cause, e.g. when the air grid is

blocked or covered. When the device has cooled suffi-

ciently, it can be started up again.

7. Faults

If the heater does not give off heat, check the fol-

lowing points:

Has the thermostat been set to the desired temper-

ature?

Has the overheat protection been triggered? See

chapter 6!

Is the fuse in the fuse box switched on?

EF 12/20TI: Is the timer knob set to OFF?

EF 12/20 TID: Set the slide switch and segments

correctly - see Chapter 5.3 "Heating Operation EF

12/20 TID"!

Glen Dimplex Deutschland GmbH

Am Goldenen Feld 18

D-95326 Kulmbach

Subject to modifications

If the fault cannot be corrected, please contact a spe-

cialist electrical service center or else your nearest

after-sales service.

To process your order, please state the production

number (E No.) and manufacturing date (FD) of the de-

vice. This information is listed on the type plate.

The device must only be repaired or manipulated by a

skilled electrician or the after-sales service.

8. Cleaning

To clean the device, first disconnect it from the mains

and allow it to cool down. Clean the outside of the unit

using a soft, damp cloth. Do not use scouring powder

or furniture polish as this may damage the surface.

Dust which gathers inside the device can be removed

from the outside using a vacuum cleaner.

9. Warranty

Please contact your local dealer for information on cus-

tomer service and warranty conditions.

10. Note on Disposal

Do not dispose of the unit with general house-

hold waste. The device must be taken to a local

waste disposal plant.

Phone: +49 9221 709-564

Fax: +49 9221 709-589

E-Mail: 09221709589@dimplex.de

www.dimplex.de/en

Manual OFF Timer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex EF12-20TID Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info