Bedienungsanleitung Dimplex FPE050E (Seite 14 von 48) (Deutsch, Englisch, Französisch, Italienisch)

798049

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

EN-3 1807/B www.dimplex.de/en

English FPE 050E - FPE 200E

NOTE

Installation on wooden walls is permissible.

Wall mounting

CAUTION!

The original wall bracket supplied on the rear

of the device must be used!

NOTE

Look out for electric cables or pipework in the wall

when drilling.

Remove the wall bracket from

the rear side of the device. To

do this, press both springs

down.

Drill the fastening holes.

Screw the wall bracket

securely to the wall.

Hook the device in the bottom slots of the wall

bracket.

Fold the device up and engage in the springs to

lock.

3. Electrical connection

The voltage specified on the type plate must match the

line voltage.

The cable must not be in contact with the casing.

It is recommended that a separate electric circuit be

provided for the power supply.

The device must only be installed and repaired by a

qualified electrician in accordance with the applicable

safety regulations. Heating device must be earthed!

Connection may only take place on securely routed

cables!

A disconnecting device with a contact opening of at

least 3 mm at each pole (e.g. circuit breaker) must be

provided in the permanently installed wiring.

The electrical connection is shown below.

Connection options

If a central temperature reduction is to take place via

the pilot wire, device connection A should be used, if

not, device connection B.

NOTE

The temperature reduction via the pilot wire has no

function if the weekly program (P1 - P6) set on the

controller is executed.

4. Overload protector

For your safety, the heating device is equipped with an

overload protector. If the air circulation is interrupted

(e.g. due to the air grille being covered or closed), the

device switches off automatically.

In this case, the power supply to the heating device

should be disconnected for a few minutes (switch off

the fuse) to allow the device to cool down sufficiently.

Before recommissioning the device, remove the

reasons for the overload protector being triggered.

5. Cleaning

The device must be disconnected from the mains and

allowed to cool down before cleaning and

maintenance. Clean the outside of the device using a

soft, damp cloth. Do not use scouring powder or

furniture polish as this may damage the surface. Dust

which gathers inside the device can be removed from

the outside using a vacuum cleaner.

 

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex FPE050E Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info