Bedienungsanleitung Dimplex GDC-AC12RW (Seite 4 von 8) (Englisch)

499324

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

5. L.E.D. DISPLAY Indicates the temperature or the time setting. After any time set

the display will return to the preset temperature automatically.

6. SPEED Press to select either LOW, MEDIUM, HIGH or AUTO fan speed.

If "AUTO" is selected, the unit operates at maximum cooling

capacity when the room temperature less the set temperature

is above 2℃.

When the room temperature less the set temperature is below

2℃, the unit operates at middle cooling capacity.

When the room temperature equal the set temperature, the

unit operates at minimum capacity.

If "HIGH" is selected, the unit operates at maximum cooling

capacity no matter what the setting temperature is . The

"MEDIUM" OR “LOW" comes to the same.

7. PROGRAMMABLE Programmable timer ON/OFF key.

TIMER TIMER-ON: The timer-on is used to turn on the unit automati-

cally after the set time is over.

(Timer-on key is correspond to the functional indicator light)

1. Press the "TIMER" key at stand-by status to set the time.

Choose the function desired(refrigeration, heat or

dehumidification.)

2. Once the set hour has come to an end, the unit will turn on

automatically.

3. Press the "POWER" key before time out, the setting time will

be cancelled and the unit will turn on.

TIMER-OFF: The timer-off is used to turn off the unit automati-

cally after the setting time is over.

Error Display

E1: Indicates open circuit or short circuit in room temperature sensor.

E2: Indicates open circuit or short circuit in pipe temperature sensor.

E7: Indicates the water is full inside.

Please contact a authorized service centre if any of the above error messages are shown.

8. SLEEP CONTROL When setting the "sleep comfort" mode please ensure that you

FUNCTION then set the number of hours required and press the timer

button till those hours are indicated on the L.E.D display. After

setting the hours the L.E.D. display will automatically return to

the current pre-set temperature. To increase this setting press

the "UP" button for each press, the temperature will be increased

by 1℃. Likewise to set for a lower temperature, press the button

indicating “DOWN”, and for each press the temperature will be

decreased by 1℃.

During the course of this cycle, to ensure maximum sleep

comfort. the micro-processor memory will raise the pre-set

temperature 0.5℃ each half hour to a maximum of 2℃ over two

hours and then maintain that temperature for the balance of the

time set.

The portable air conditioner is fitted with a 3 minutes compressor

delay protection circuit which simply means that the compressor

requires 3 minutes to start. From either being switched on, or

when changing from “dehumidify” to any air conditioning cycle

chosen.

9.”E7” When the unit warns of full water, please unplug the water

stopper at the back of the unit and then lean the unit to drain the

water out. Then the unit can be restarted. If the E7 is presented

again, please find a specialized person to repair.

GDC-AC9RCS/GDC-AC9RCW/GDC-AC12RCB/GDC-AC12RCW with heating

function

Note: Heating function does not operate if the ambient temperature is over 23

℃.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex GDC-AC12RW Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info