Bedienungsanleitung Dimplex HPL 6S-TUW2 (Seite 27 von 52) (Deutsch, Englisch, Französisch)

798227

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

www.glendimplex.de 452163.66.69 · FD 0010 EN-11

HPL 6S-TUW2 English

for domestic hot water inches 1“ AG

for circulation pipe inches 3/4“ IG

for expansion vessel inches 1“ AG/FL

6.12 Anode diameter HWK mm 26

6.13 Anode length HWK mm 1100

6.14 Anode connection thread HWK inches G 1“

6.15 Weight of the transport unit(s)

incl. packaging HWK kg 195

7 Electrical connection

7.1 Supply voltage / fusing / RCD type 3~/N/PE 400 V (50 Hz) / C10 A / A

7.2 Control voltage / fusing by WPM 1~/N/PE 230 V (50 Hz) / 4 AT

7.3 Degree of protection according to EN 60529 IP 24

7.4 Starting current limiter No

7.5 Rotary field monitoring No

7.6 Starting current A 28

7.7 Nominal power consumption A2/W35 /

max. power consumption 2 kW 1.4 / 2.93

7.8 Nominal current A2 /W35 / cos  A / --- 2.53 / 0.8

7.9 Power consumption of compressor protection

(per compressor) W / --- -

7.10 Power consumption of fan W < 125

7.11 Control voltage, fusing HWK 1~ / N / PE 230V (50Hz) / C 13A

7.12 Supply voltage / fusing

(∑ P = 3.5 kW) HWK 1~ / N / PE 230V (50Hz) / B16A

HWK 1~ / N / PE 400V (50Hz) / B10A

8 Complies with the European safety regulations 7

9 Additional model features

9.1 Type of defrosting Reverse circulation

9.2 Frost protection, condensate tray /

Water in device protected against freezing8Yes

9.3 Maximum operating pressure (heat sink) bar 3.0

10 Heat output COP 2

10.1 Heat output / COP EN 14511

at A-7 / W35 kW / --- 4.0 / 2.9

at A2 / W35 kW / --- 5.1 / 3.9

at A7 / W35 kW / --- 6.4 / 4.7

at A7 / W45 kW / --- 6.1 / 3.6

at A10 / W35 kW / --- 6.7 / 4.8

1. For air temperatures between -22°C and -5°C, flow temperature increasing from 45? to 60?.

2. These data indicate the size and capacity of the system according to EN 14511. For an analysis of the economic and energy efficiency of the system, other parameters, in

particular the defrosting capacity and regulation, should also be taken into consideration. These figures are only achieved with clean heat exchangers. Instructions for care,

commissioning and operation can be found in the relevant sections of the installation and operation instructions. The specified values have the following meaning, e.g. A7/

W35: outside air temperature 7 °C and heating water flow temperature 35 °C.

3. The heat output and COP is reduced by approx. 5 % in lower operation

4. The maximum sound power level under full load can increase by up to 5 dB(A).

5. The specified sound pressure level represents the free sound area level. The measured value can deviate by up to 16 dB(A), depending on the installation location.

6. Note that additional space is required for pipe connections, operation and maintenance

7. See CE declaration of conformity

8. The heat circulating pump and the heat pump manager must always be ready for operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex HPL 6S-TUW2 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info