14 www.dimplex.com
Maintenance
④ Gently pull the flicker rod to
the right as far as possible into
the rubber bushing on the flicker
motor shaft (Figure 7).
⑧ Replace glass assembly.
Glass Cleaning
The glass is cleaned in the factory
during the assembly operation.
During shipment, installation,
handling, etc., the glass may
collect dust particles; these can
be removed by dusting lightly with
a clean dry cloth.
To remove fingerprints or other
marks, the glass can be cleaned
with a damp cloth. To prevent
scratching, do not use abrasive
cleaners or spray liquids on the
glass surface.
Figure 7
Exploded view to show detail
Flicker Rod
Flicker
Motor
Bulbs (2)
⑤ Unscrew bulbs counter
clockwise.
⑥ Insert new bulbs.
⑦ Install the log set by placing
the front, bottom edge of the
ember bed in the track behind
the front panel. Once in place,
push down on the back edge of
the ember bed until the rear tab
snaps into place under the mirror
(Figure 8).
!
NOTE: Ensure the log set is
installed tightly under the back
ledge to prevent light leakage.
Back
Ledge
Log
Ember Bed
Rear
Tab
Side Section
Figure 8
Front
Edge
Screw Location
O
