Bedienungsanleitung Dimplex Scandic (Seite 4 von 16) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch, Norwegisch)

706524

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Thermal Safety Cut-out

The built-in overheat cut-out, switches off the appliance

automatically in the event of a fault! Should this occur

switch off the appliance or disconnect the mains plug

from the socket.

Remove any obstructions which may have caused the

overheating. After a short cooling down phase, the

appliance is ready for use again! If the fault should occur

again, contact your local dealer!

WARNING: In order to avoid a hazard due to inadvertent

resetting of the thermal cut-out, this appliance must not be

supplied through an external switching device, such as a

timer, or connected to a circuit that is regularly switched

on and off by the utility.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.

Light Emitting Diode

This re is tted with LED (Light Emitting Diode) lamps. These

LED lamps are maintenance-free and should not require

replacing during the life of the product.

Cleaning

WARNING: ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE CLEANING THE HEATER.

For general cleaning use a soft clean duster – never use

abrasive cleaners. The glass viewing screen should be

cleaned carefully with a soft cloth.

DO NOT use proprietary glass cleaners.

To remove any accumulation of dust or uff the soft brush

attachment of a vacuum cleaner should occasionally be

used to clean the outlet grille of the fan heater.

WARNING: do not operate the product without the grille

and outer glass in position as this may effect the operation

of the heater.

Recycling For electrical products sold within the European

Community. At the end of the electrical

products useful life it should not be disposed

of with household waste. Please recycle

where facilities exist. Check with your Local

Authority or retailer for recycling advice in

your country.

After Sales Service

Should you require after sales service or should you need

to purchase any spares, please contact the retailer from

whom the appliance was purchased or contact the

service number relevant to your country on the warranty

card.

Please do not return a faulty product to us in the rst

instance as this may result in loss or damage and delay

in providing you with a satisfactory service. Please retain

your receipt as proof of purchase.

Controls: See Fig. 2

Three switches provide a choice of heat settings. A switch

is in the ON position when the side with the markings on

(i.e. I, I, or II) is pushed in.

Switch 1 (I) Controls the electricity supply to the heater

and ame effect.

Note: This switch must be in the ON (I)

position for heater to operate with or

without heat.

Switch 2 (I) Provides 1 kW heat output

Switch 3 (II) Provides 2 kW output with switch 2

Thermostat (T) - see Fig. 3

In order to maintain a certain room temperature, set the

controller to ‘max.’. Operate the appliance at full power

until the required room temperature is reached. Set back

the thermostatic controller until the appliance switches off

with an audible ‘click’. This temperature will be kept almost

constant by the thermostatic control switching on and off

automatically. Please note that the appliance can only

be switched on when the thermostat setting is higher than

the room temperature.

Remote Control - See Fig. 4

The maximum range of use is ~ 5metres.

NOTE: It may take a short time for the receiver to respond

to the transmitter.

NOTE: The receiver for the remote control’s location is

indicated by the symbol shown in Fig.1, aim the remote

control in this direction when inputting commands.

Do not press the buttons more than once within two

seconds for correct operation.

Battery Information - See Fig. 4

1. To activate the remote control remove the clear battery

isolation strip at the base of the remote control, which

is used to ensure your remote control reaches you fully

charged.

2. To replace the remote control battery, turn over the

remote control, and follow the diagram embossed on the

remote control.

3. Only use CR2025 or CR2032 size of batteries.

Fitting

NOTE: Tipping restraint kit is only supplied with suites.

WARNING: FALLING OR TIPPING APPLIANCES CAN

CAUSE INJURY OR DEATH OF YOUNG CHILDREN, PLEASE

ENSURE CHILDREN DO NOT CLIMB, HANG OR STAND ON

THIS PRODUCT.

WARNING: THE APPLIANCE IS PROVIDED WITH A TIPPING

RESTRAINT, THIS RESTRAINT IS NOT A SUBSTITUTE FOR

PROPER ADULT SUPERVISION. THIS RESTRAINT MAY PROVIDE

PROTECTION AGAINST TIPPING FURNITURE. DO NOT ALLOW

CHILDREN TO CLIMB ON FURNITURE. FAILURE TO DETACH

THIS RESTRAINT BEFORE MOVING FURNITURE MAY RESULT IN

INJURY AND DAMAGE.

This product is provided with a ‘Tipping Restraint Kit’ as

shown in Fig 5, to prevent the product accidentally tipping

over. Fitting Instructions are supplied with this kit please

follow these instructions carefully.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex Scandic Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info