Bedienungsanleitung Dimplex SI 75TU (Seite 21 von 68) (Deutsch, Englisch, Französisch)

798240

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

www.gdts.one 452237.66.50 · FD 9912 EN-3

SI 50TU - SI 75TU English

1.3 Legal regulations and directives

This heat pump is designed for use in a domestic environment

according to Article 1, Paragraph 2 k) of EU directive 2006/42/

EC (machinery directive) and is thus subject to the require-

ments of EU directive 2014/35/EU (low-voltage directive). It is

thus also intended for use by non-professionals for heating

shops, offices and other similar working environments, agricul-

tural establishments and hotels, guesthouses and other resi-

dential buildings.

This heat pump conforms to all relevant DIN/VDE regulations

and EU directives. Refer to the EC Declaration of Conformity in

the appendix for details.

The heat pump must be connected to the power supply in

compliance with all relevant VDE, EN and IEC standards. Any

further connection requirements stipulated by local utility com-

panies must also be observed.

The heat pump is to be connected to the heat source system

and the heating system in accordance with all applicable regu-

lations.

This unit can be used by children aged 8 and over and by per-

sons with limited physical, sensory or mental aptitude or lack of

experience and/or knowledge, providing they are supervised or

have been instructed in the safe use of the unit and understand

the associated potential dangers.

Children must not play with the device. Cleaning and user

maintenance must not be carried out by children without su-

pervision.

ATTENTION!

Work on the heat pump must only be performed by

authorised and qualified after-sales service technicians!

ATTENTION!

When operating or maintaining a heat pump, the legal

requirements of the country where the heat pump is operated

apply. Depending on the refrigerant fill quantity, the heat

pump must be inspected for leaks at regular intervals by a

certified technician, and these inspections must be recorded.

More information can be found in the accompanying log book.

1.4 Energy-efficient use of the heat

pump

By operating this heat pump you are helping to protect our en-

vironment. Both the heating system and the heat source must

be properly designed and dimensioned to ensure efficient op-

eration. It is particularly important to keep water flow tempera-

tures as low as possible. All connected heat consumers should

therefore be suitable for low flow temperatures. Raising the

heating water temperature by 1 K corresponds to an increase in

electricity consumption of approx. 2.5 %. Low-temperature

heating systems with flow temperatures between 30 °C and

50 °C are particularly well-suited for energy-efficient operation.

2 Intended use of the heat

pump

2.1 Intended purpose

The brine-to-water heat pump is to be used exclusively for the

heating of heating water. It can be used in new or existing heat-

ing systems. A mixture of water and frost protection (brine) is

used as a heat transfer medium in the heat source system.

Borehole heat exchangers, ground heat collectors or similar

systems can be used as the heat source system.

2.2 Operating principle

The heat generated by the sun, wind and rain is stored in the

ground. This heat stored in the ground is collected at a low tem-

perature by the brine circulating in the ground heat collector,

the borehole heat exchanger or a similar system. A circulating

pump then conveys the "heated" brine to the evaporator of the

heat pump. There the heat is given off to the refrigerant in the

refrigeration circuit. This cools the brine so that it can once

again absorb thermal energy in the brine circuit.

The refrigerant is drawn in by the electrically driven compres-

sor, compressed and "pumped" to a higher temperature level.

The electrical power needed to run the compressor is not lost in

this process. Most of it is absorbed by the refrigerant.

The refrigerant subsequently passes through the liquifier where

it transfers its thermal energy to the heating water. Depending

on the set operating point, the heating water can thus be

heated up to a max. of 62 °C.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex SI 75TU Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info