Bedienungsanleitung Dimplex SIW 6TES (Seite 35 von 76) (Deutsch, Englisch, Französisch)

798306

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

www.gdts.one 452236.66.09 · FD 9912 EN-13

SIW 6TES - SIW 11TES English

9 Cleaning / maintenance

9.1 Maintenance

To prevent faults due to sediment in the heat exchangers, care

must be taken to ensure that no impurities can enter either the

heat source system or the heating system. In the event that op-

erating malfunctions due to contamination occur nevertheless,

the system should be cleaned as described below.

9.2 Cleaning the heating system

The ingress of oxygen into the heating water circuit may result

in the formation of oxidation products (rust), particularly if steel

components are used. These enter the heating system via the

valves, the circulating pumps and/or plastic pipes. It is there-

fore essential - in particular with respect to the piping of under-

floor heating systems - that only diffusion-proof materials are

used.

NOTE

We recommend the installation of a suitable corrosion

protection system to prevent the formation of deposits (e.g.

rust) in the condenser of the heat pump. We recommend

equipping diffusion-open heating systems with an

electrophysical anti-corrosion system

(e.g. ELYSATOR system).

Residue from lubricants and sealants may also contaminate the

heating water.

In the event of severe contamination leading to a reduction in

the performance of the liquefier in the heat pump, the system

must be cleaned by a heating technician.

Based on current knowledge, we recommend carrying out the

cleaning with a 5 % phosphor acid or, if more frequent cleaning

is required, with a 5 % formic acid.

In both cases, the cleaning fluid should be at room tempera-

ture. We recommend flushing the heat exchanger in the direc-

tion opposite to the normal flow direction.

To prevent acidic cleaning agents from entering the heating

system circuit, we recommend connecting the flushing device

directly to the flow and return of the liquifier. It is then important

that the system be thoroughly flushed using appropriate neu-

tralising agents to prevent any damage from being caused by

cleaning agent residue remaining in the system.

Acids must be used with care and the regulations of the em-

ployers’ liability insurance associations must be adhered to.

The manufacturer's instructions regarding cleaning agent must

be complied with at all times.

9.3 Cleaning the heat source

system

ATTENTION!

The supplied dirt trap must be inserted in the heat source inlet

of the heat pump to protect the evaporator against the ingress

of impurities.

The filter sieve of the dirt trap should be cleaned one day after

start-up. Further checks must be set according to the level of

dirt. If no more signs of contamination are evident, the filter can

be removed to reduce pressure drops.

10 Faults / troubleshooting

This heat pump is a quality product and is designed for trouble-

free operation. In the event that a fault should occur, it will be

indicated on the heat pump manager display. In this case, con-

sult the "Faults and troubleshooting" page in the operating in-

structions of the heat pump manager.

If you cannot correct the fault yourself, please contact your

after-sales service technician.

ATTENTION!

Work on the heat pump must only be performed by

authorised and qualified after-sales service technicians!

ATTENTION!

Disconnect all electrical circuits from the power source prior

to opening the device.

11 Decommissioning / disposal

Before removing the heat pump, disconnect it from the power

source and close all valves. The heat pump must be installed by

trained personnel. Observe all environmental requirements re-

garding the recovery, recycling and disposal of materials and

components in accordance with all applicable standards. Par-

ticular attention should be paid to the proper disposal of refrig-

erants and refrigerant oils.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dimplex SIW 6TES Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info