Bedienungsanleitung Dirt Devil M 2012 Lifty PLUS (Seite 12 von 24) (Deutsch, Englisch, Französisch)

500169

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

3 Before use

3.1 Unpacking

1. Unpack the appliance and all its accessories.

2. Check that the contents are intact (Fig. 1).

3.2 Selecting the proper nozzle

1. Select the nozzle according to the surface to be cleaned:

- Floor nozzle (Fig. 2/1):

It can be used everywhere and, thanks to its switch, can be used

equally well on carpets and hard floors.

- Parquet brush (Fig. 2/2):

Its long bristles make it especially suitable for cleaning delicate

surfaces (e.g. parquet and laminate floors).

- Crevice nozzle (Fig. 2/3):

Use this to vacuum dust from hard to reach places.

- Furniture brush (Fig. 2/4):

Use this to vacuum dust off objects that have sensitive surfaces.

- Long flexible crevice nozzle (Fig. 2/5):

Use this to vacuum dust from distant, hard-to-reach places.

2. Push the accessory holder onto the telescopic tube as shown, or onto

the handle (Fig. 3/A).

3. Push nozzles not in use onto the stubs of the accessory holder (Fig. 3/

B).

4. Keep the other nozzles safe and inaccessible to children.

3.3 Assembly

1. Attach the selected nozzle to the bottom end of the telescopic tube

(Fig. 4/A1) or of the handle (Fig. 4/B1).

2. Insert the end of the suction hose into the intake opening (Fig. 5/A) of

the vacuum cleaner until you hear and feel it locking into place.

If using the telescopic tube:

3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).

4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the

release latch on the tube to do this. Then extend the telescopic tube to

the desired length. Let go of the release catch while pulling until it locks

in place. You will hear a distinct click.

ATTENTION:

Always transport or ship the appliance in its original packaging to avoid

damage.

Keep the packaging for such an event.

However, dispose of no longer needed packaging material properly.

NOTE:

Immediately contact your dealer if you have found damage resulting

from transport.

NOTE:

When you use the long, flexible crevice nozzle, under certain circum-

stances the pressure inside the vacuum cleaner might drop too far thus

triggering the safety valve. The signal for this is e.g. a whistling noise

(depending on the vacuum cleaner model) and greatly reduced suction

performance. In this case, depending on the vacuum cleaner model and

equipment, you have to reduce the suction power or open the bypass

vent until the valve no longer triggers.

WARNING:

Danger of injury! Only attach the nozzles if the appliance is not

connected to the power supply. The cylinder vacuum cleaner could be

switched on by accident.

ATTENTION:

Before vacuuming, make sure that the fitted nozzle suits the surface to

be cleaned. Also observe the flooring manufacturer's recommendations.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dirt Devil M 2012 Lifty PLUS Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info