Bedienungsanleitung Dirt Devil m 5038 1 carbon infinity vs8 loop (Seite 12 von 21) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Türkisch)

320836

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

Maintenance

Infinity VS8 Loop

4 Maintenance

4.1 Emptying the dust container

 Empty the dust container after each

vacuuming session, but at the latest when the

"MAX" mark (Fig. 17/1) has been reached.

1. Remove the dust container by pushing the

release button (Fig. 17) and then remove

the dust container from its console.

2. Empty the dust container by holding it low

over a dust bin and only then push the

release catch of the bottom plate (Fig. 18/

A1).

3. On this occasion, also take out the cyclone

unit by unlatching it as shown (Fig. 18/B,

the arrow will move from to ).

4. Remove any residual dust that may have

collected in the dust compartment.

5. Clean the cyclone unit by wiping it with a

dry cloth or by brushing it with a dry soft

brush, e.g. the furniture brush supplied with

the appliance.

6. Replace the cyclone unit and secure it by

turning clockwise (the arrow will move from

to ).

7. Fold the bottom plate back up.

8. Also check the dual motor protection filter

on this occasion. Clean it if necessary,

Zchapter 4.4, „Cleaning the dual motor

protection filter“.

9. Put the dust container back into its holder.

You must feel and hear it click into place.

4.2 Overview of the filters

The filters can get dirty during use and

therefore must be checked regularly:

 Keep the checking and cleaning intervals

given below.

 Clean the filters as described below.

 Damaged or deformed filters, however,

must be replaced immediately.

The following 2 filters are installed:

 Dual motor protection filter (Fig. 19/1)

- Checking: Check the dual motor

protection filter for dirt and possible

damage every time you empty the dust

container.

- Cleaning If during checking you see that

the filter is dirty, clean it as described

below (Zchapter 4.4, „Cleaning the dual

motor protection filter“). However, the

filter should be cleaned at least every 3 –

6 months.

 Exhaust filter (Fig. 19/2)

- Checking: Check the exhaust filter

regularly for dirt and possible damage, at

least every 3 – 6 months.

- Cleaning: If during checking you see that

the filter is dirty, clean it as described

below.

4.3 Cleaning the exhaust filter

1. Switch off the appliance.

2. Push the release catch of the exhaust filter

cover to the side and fold down the exhaust

filter cover (Fig. 20).

3. Remove the exhaust filter.

4. Clean the hygienic exhaust filter by tapping

out the dirt over a dustbin. Should this be

insufficient, clean the the filter with a soft

brush, e.g. the furniture brush supplied with

the appliance.

If this dry cleaning is still insufficient, then

rinse the filter in clear cold water.

5. If the filter is damaged or deformed, replace

it. (Zchapter 6, „Spare parts“).

6. Put the clean exhaust filter back into its

holder.

7. Attach the exhaust filter cover at the bottom

side first and then fold it shut.

8. To secure it you must guide the latch by

hand as during unlatching until you hear

and feel it snap into place.

4.4 Cleaning the dual motor

protection filter

1. Switch off the appliance, remove the dust

container and empty it Zchapter 4.1,

„Emptying the dust container“.

2. Open the latch of the motor protection filter

cover and take out the dual motor

protection filter (Fig. 21).

3. Hold the dual motor protection filter deep

inside a dustbin and only then separate the

filter elements from each other.

4. Thoroughly rinse both filter elements by

hand with clear cold water.

5. If a filter element is damaged or deformed,

replace it by a new one. (Zchapter 6,

„Spare parts“).

6. Put the filter elements back together again.

7. Close the motor protection filter cover by

folding it shut. The latch must snap shut.

8. Put the dust container back into the

appliance. It must catch with a click.

ATTENTION:

Switch off the appliance before emptying the

dust container. This will prevent dust from

damaging the appliance.

NOTE:

You can dispose of the dust filter bag with

your regular domestic trash as long as it

contains no waste materials prohibited in

domestic trash.

MAX

ATTENTION:

The filter is washable, but not suitable for

cleaning in washing machines or

dishwashers. Also, do not use cleansers for

cleaning the filters. Leave the filter element

to dry after cleaning (approx. 24 hours at

room temperature). Only put it back into the

appliance when it is completely dry.

ATTENTION:

The filter elements are washable, but not

suitable for cleaning in washing machines or

dishwashers. Also, do not use cleansers for

cleaning the filters. Then leave the filter

elements to dry (approx. 24 hours at room

temperature). Only put them back into the

appliance when they are completely dry.

Infinity VS8.book Seite 12 Mittwoch, 23. Februar 2011 11:58 11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dirt Devil m 5038 1 carbon infinity vs8 loop Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info