Bedienungsanleitung Dirt Devil m 7021 bagline (Seite 9 von 16) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Türkisch)

321079

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Operation

2 Operation

2.1 Unpacking

1. Unpack the appliance with all its

accessories.

2. Check that the contents are complete and

intact (Figs. 1 – 4).

2.2 Assembly

1. Push the end of the suction hose into the

socket as shown until the catch snaps into

place (Fig. 5/A).

2. Push the nozzle onto the lower end of the

telescopic tube (Fig. 5/B).

3. Insert the handle into the upper end of the

telescopic tube (Fig. 6/A).

4. Adjust the length of the telescopic tube. To

do this, press the telescopic tube lock down

(Fig. 6/B1). Then extend the telescopic

tube to the desired length (Fig. 6/B2). To

engage the lock of the telescopic tube,

release the catch while pulling. You will

hear a distinct click.

5. Attach accessories temporarily not in use to

the accessory holder on the suction tube

(Fig. 2).

Your vacuum cleaner is now ready for use.

2.3 Vacuum cleaning

1. Push on the desired nozzle, .

Observe the recommendations of the

flooring manufacturers.

2. When using the floor nozzle, adjust the

"carpet/hard floor" switch according to the

type of flooring:

for smooth floors, e.g. laminate,

tiles, PVC, etc.

for deep- and short-pile carpets,

runners, etc.

3. Pull out the power cord until the yellow

marking is visible. (Fig. 7/5).

4. Insert the mains plug into a socket with

ground/safety contact.

5. Switch on the vacuum cleaner with the on/

off switch (Fig. 7/3).

6. Set the power control (Fig. 7/1) to suit the

type of floor to be cleaned.

7. When working with the vacuum cleaner,

pull if after you like a sleigh.

2.4 Switching off

1. Switch off the vacuum cleaner with the on/

off switch (Fig. 7/3) and pull the plug from

the mains socket.

2. Keep the plug in your hand.

3. Press the cable retraction button (Fig. 7/2)

to pull in the power cord.

2.5 Transportation and storage

 To transport the appliance you can carry it

by the carrying-handle (Fig. 8/1) or by the

carrying-hole (Fig. 8/2) .

 When storing the appliance or during

work breaks, you can hang the storage hook

(Fig. 9/1) into the bracket on the housing

(Fig. 9/2).

We recommend to first telescope the

telescopic tube Zchapter 2.2, „Assembly“,

step 4).

 For long-time storage remove the dust

filter bag Zchapter 3.1, „Changing the dust

filter bag“ and dispose ot it properly. Always

store the appliance in a cool, dry place and

keep it out of reach of children.

NOTE:

Consult your dealer immediately if you detect

damage due to transport.

ATTENTION:

Principally ship or transport the appliance

only in its original packaging to avoid

damage. Keep the packaging for such an

event.

Dispose of no longer needed packaging

material properly.

WARNING:

Danger of injury! Only assemble the

appliance if it is not connected to the mains.

Otherwise the appliance could start up and

limbs, hair or pieces of clothing might be

sucked in.

A B

WARNING:

Danger of injury! A damaged appliance must

not be used. Check the vacuum cleaner and

the power cord each time before using it.

WARNING:

Danger of injury! Especially when cleaning

stairs take care that you always stand above

the appliance.

ATTENTION:

Only use the vacuum cleaner with all filters

intact, in dry condition and correctly placed.

Make sure that the openings of the vacuum

cleaner are not clogged.or obstructed.

Otherwise the vacuum cleaner might be

damaged.

NOTE:

Your vacuum cleaner is equipped with a

safety switch to prevent overheating. It

automatically cuts off the power supply if the

motor is overheated. In this case switch off

the vacuum cleaner and disconnect it from

the mains. Remove the cause of the

overheating. Wait for about 45 minutes. After

it has cooled off, you may use the vacuum

cleaner again.

WARNING:

Danger of electric shock! If the red marking

shows (Fig. 7/4) retract the cord by pressing

the retract button to pull in the cable (Fig. 7/

2) up to the yellow mark again. Otherwise

the cable can break off.

NOTE:

With the bypass vent (Fig. 1/5) you can

quickly reduce the suction power if less

power is needed, or to release objects

accidentally sucked in.

WARNING:

Danger of injury! During uncontrolled

retraction the power cord can whip around,

become an obstacle or overthrow objects.

Therefore, keep the plug in your hand and

guide the cord during retraction.

ATTENTION:

Never store the appliance next to heat

sources (e.g. stoves or radiators). Avoid

exposing it to direct sunlight. The heat might

damage the appliance.

M7021.book Seite 9 Dienstag, 21. April 2009 1:53 13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dirt Devil m 7021 bagline Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info