500142
14
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
14
4 Maintenance
4.3 Cleaning / changing the laminar motor protection filter
1. Switch off the appliance Zchapter 3.1, „Switching off“.
2. Remove the dust container Zchapter 3.4, „Emptying and cleaning the dust container“.
3. Hold the dust container low over a dustbin.
4. Push the release catch of the holder of the foam plastic motor protection filter (Fig. 17/1) and fold it
downwards.
5. Pull the foam plastic motor protection filter out of its holder (Fig. 17).
6. Also remove the laminar motor protection filter (Fig. 18/arrow) from its receptacle.
7. For a rough cleaning, tap the dirt from both filter elements by lightly beating them over a dustbin.
8. Remove larger agglomerations of dirt by hand.
9. Should this be insufficient, clean the the filter with a soft brush, e. g. the furniture brush supplied with the
appliance.
10. If the filter elements are still dirty after this procedure, thoroughly rinse them by hand (Fig. 19/A) until all
dirt has been removed. Only running cold or lukewarm water to rinse the filter elements.
11. If a filter element is damaged or too dirty, replace it with a new one (ordering information Zchapter 5.2,
„Accessories/Spare Parts“).
12. Put the new / cleaned and completely dry motor protection filter back into its receptacle (Fig. 20). Use both
hands to push it into its proper position (Fig. 20/arrows).
13. Put the new / cleaned and completely dry foam plastic motor protection filter back into its holder (Fig. 17).
14. Fold the filter holder back up against the dust container until you feel and hear the release catch of the filter
holder (Fig. 17/1) snap into place.
15. Put the dust container back into its receptacle. You must feel and hear it clicking into place.
16. Check that the dust container is fitted securely.
4.4 Cleaning / changing the exhaust filter
1. Switch off the appliance.
2. Push the release catch of the exhaust filter cover to the right (Fig. 21/arrow) and fold down the exhaust filter
cover.
3. Remove the exhaust filter (Fig. 22).
4. Knock the exhaust filter over a dustbin for a rough cleaning.
5. Remove larger agglomerations of dirt by hand.
6. Then thoroughly rinse the filter Only rinse the filter in clear running cold or hand-warm water.
7. Ifthe filter is damaged or deformed, replace it.(ordering information Zchapter 5.2, „Accessories/Spare
Parts“).
8. Put the new / cleaned and completely dry exhaust filter back into its receptacle.
9. Fit the exhaust filter cover on the right side first and then fold it in to the left.
10. Check the cover for correct fit.
ATTENTION:
The filter elements are washable, but may not be cleaned in dishwashers or washing-machines. Also, do not
use detergents or brushes with hard bristles to clean the filters. Let the filter elements dry for approx 24 hours
at room temperature after cleaning (Fig. 19/B). Only put them back into the appliance when they are
completely dry.
1
17
18
24
19
18
17
16
15
14
20
21
22
23 13
19
20
ATTENTION:
The filter is washable, but it may not be cleaned in dishwashers or washing-machines. Also, do not use
detergents or brushes with hard bristles to clean the filters. Let the filter dry for approx 24 hours at room
temperature after cleaning it. Only put it back in place when it is completely dry.
21
22
M2700.book Seite 14 Mittwoch, 6. April 2011 2:50 14
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Dirt Devil M2700 - Centrino SX3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info