Bedienungsanleitung Dirt Devil POPSTER - DD2324 (Seite 13 von 24) (Deutsch, Englisch, Französisch)

590978

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

3 Service and maintenance

3.1 Empty dust bin and clean filter elements

1. Switch off the appliance ( ).

2. Pull the plug out of the plug socket.

3. Remove the dust bin (Fig. 16).

4. Empty the dust bin (Fig. 17).

5. Take this opportunity to also check the filter elements (dual motor pro-

tection filter and filter unit) in the dust bin (Fig. 18 – 22).

6. If the filter elements (dual motor protection filter and filter unit) are dirty,

clean them under cold or lukewarm running water until all dirt has gone

(Fig. 23).

7. Let the filter elements dry (for approx. 24 hours at room temperature,

Fig. 24) after wet cleaning.

8. Insert the filter elements again (Fig. 25 – 28).

9. Re-insert the dust bin (Fig. 29).

You must be able to feel and hear it click into place.

click!

2726

2524

24 h

NOTE:

The dust bin has to be emptied and cleaned regularly. Otherwise empty-

ing it will get harder and harder or smells and bacteria might develop,

depending on what you have vacuumed up.

 Therefore, it is best to empty the dust bin after each vacuuming ses-

sion.

 Empty and clean the dust bin at least

- every 3 months,

- before prolonged storage or

- before shipping the appliance.

CAUTION:

Switch off the appliance before removing the dust bin. This will prevent

dust from damaging the appliance.

NOTE:

You can dispose of the content of the dust bin with your domestic waste

as long as the dirt does not contain any substances prohibited for

domestic waste.

CAUTION:

The filter elements are washable, but may not be cleaned in dishwash-

ers or washing machines.

 Do not use cleaning agents or brushes with hard bristles to clean the

filter elements.

 Let the filter elements dry (for approx. 24 hours at room temperature,

Fig. 24) after wet cleaning.

 Do not re-install them until they are completely dry.

 Replace damaged or deformed filters immediately (for ordering infor-

mation see ZChapter 3.4, ‘Spare parts and accessories’).

NOTE:

The filter elements are designed so that they can only be fully inserted if

in the right position.

 Nevertheless, it is helpful if you align the filter unit properly with the

dust bin as shown in Fig. 26 before inserting it.

 Then lower the filter unit completely into the dust bin until the three

noses of the dust bin engage with the respective recesses of the filter unit

(Fig. 26).

 Do not use force upon insertion. If the dust bin lid (Fig. 28) will not

shut properly, you have to take the parts out again and put them back in.

CAUTION:

Never operate the appliance without the filters in place.

Never operate the appliance with damaged filters.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dirt Devil POPSTER - DD2324 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Dirt Devil POPSTER - DD2324

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info