Operating Temperature 14° to 104° F (-10° to 40° C)
Max Charging Power 180 W
7
.1
6 in
6
.
77
in
4.14 in
2.80 in
FCC ID： SS3-WM6101410 FCC ID： SS3-GL6581502
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
●
Calibrating the Compass
Ensure the compass is calibrated before every flight. Failure to do so may lead to unexpected flight behavior.
●
DO NOT attempt to calibrate your compass where there is a chance of strong magnetic interference, including areas near
massive metal objects, parking lots, underground steel reinforcements or under bridges.
●
DO NOT carry ferromagnetic materials, such as keys and mobile phones, with you during compass calibration.
●
The compass should always be calibrated when moving from indoor spaces to outdoor spaces.
●
After successful calibration, the compass may become abnormal when you place the aircraft on the ground. This may be
because of underground magnetic interference. Move the aircraft to another location and try again.
Always
fly under
400 ft
1
7
.7
6
i
n
12.44 in
17.24 in
●
The aircraft will not avoid obstacles while it is returning to the Home Point, and an appropriate RTH altitude must be set before takeoff. You
should also use the control sticks to guide the aircraft. Refer to the Safety Guidelines and Disclaimer for more details.
●
Positioning Systems (P-Mode)
The aircraft uses GPS and a Vision Positioning System (VPS)
to pinpoint its position and stabilize flight. It is strongly
advised to fly in P-Mode which, depending on the GPS
signal and aircraft altitude, has one of the following states:
P-GPS: GPS and VPS are used for positioning. The aircraft
can return home.
P-OPTI: Only VPS is used for positioning (< 9.8 feet). The
aircraft cannot return home.
P-ATTI: GPS and VPS are not available. The aircraft can
maintain balance but will drift from side to side. It cannot
return home.
The effective altitude for the Vision Positioning System is
below 9.8 feet. The Vision Positioning System will not work
properly over surfaces that do not have pattern variations,
over water or in low light conditions (< 100 lux).
Toggle the flight mode switch on the remote controller
to ‘P’ and wait for a stable satellite count before takeoff.
●
Return-to-Home
It is important to take off with a strong GPS signal
(green bars) to ensure that the Home Point is
recorded by the aircraft. The aircraft will
automatically return to the Home Point in the
following cases.
Smart RTH: The pilot presses the RTH button.
Low Battery RTH: The battery level is low or
critically low.
Failsafe RTH: Remote controller signal is lost.
DO NOT FLY in rain, snow, fog, and wind
speeds exceeding 22 mph or 10 m/s.
It is important to understand basic
flight guidelines for the safety of
both you and those around you.
Refer to the Safety Guidelines and
Disclaimer for more information.
DO NOT FLY near or above people, near
trees, power lines or buildings.
Learn more:
http://flysafe.dji.com/no-fly
No Fly Zones
DO MONITOR YOUR ALTITUDE
and fly under 400 feet
(120 meters).
DO MAINTAIN LINE OF SIGHT
and avoid flying behind buildings
or obstacles that block your view.
DJI encourages you to enjoy flying in a safe, responsible and smart way.
●
Be very careful when flying 14,700 feet (4,500 meters) or more above sea level as the battery and aircraft performance may be reduced.
●
The Inspire 1 Pro’s compass and GPS will not work in Polar Regions. The aircraft will auto switch to ATTI Mode and use the VPS for positioning.
Vision Positioning
Effective Altitude:
≤ 9.8 feet
GPS Positioning
INSPIRE 1
PRO
11. Gimbal Dial
12. Camera Settings Dial
13. Record Button
14. Flight Mode Switch
15. Shutter Button
16. Playback Button
17. Mini HDMI Port
18. Micro USB Port
19. CAN Bus Port
20. USB Port
21. C1 Button
22. C2 Button
10
4
9
8
5
6
1
3
7
2
21
171819
20
11
14
13
12
1615
The Inspire 1 Pro features the Zenmuse X5 gimbal and camera equipped with a 15mm f/1.7 (35mm format equivalent
30mm) Micro Four Thirds interchangeable lens. It shoots sharp 16MP stills and stable video at up to 4K. The aircraft’s
retractable landing gear pulls up out of view, giving the camera an unobstructed 360 degree view of the world below.
Through the DJI GO app, the camera focus, shutter speed, aperture and ISO can be manually adjusted. The DJI Focus,
a wireless follow focus system, can be linked to the remote controller of the Inspire 1 Pro for seamless and tactile camera
control across the entire flight range.
An advanced flight controller makes the Inspire 1 Pro stable, safe and easy to fly indoors or out. The revolutionary Vision
Positioning System (VPS) gives it the power to hover in position at low altitudes even without GPS. Like all DJI flight
controllers, it is also able to return home if remote controller signal is lost or if the low battery warning is triggered.
The Inspire 1 Pro boasts a maximum flight speed 18m/s* and a maximum flight time of 15 minutes* using one fully charged
4500 mAh Intelligent Flight Battery.
The maximum transmission distance of the Inspire 1 Pro remote controller is 16,400 feet (5 km)*. The built-in LiPo battery
powers the device for up to four hours in between charges.
An ergonomic design puts photo and video capturing, playback and gimbal control functions within comfortable reach,
crucial when the aircraft is being operated. Important controls such as raising and lowering the landing gear and activating
the Return-to-Home procedure can also be triggered with a tap of a button.
The Lightbridge HD video downlink is integrated into the remote controller, allowing real-time camera footage to be
displayed in the DJI GO app. Dual remote controller mode makes it possible for the aircraft and camera to be operated
on two separate controls, which have a communication range of up to 50 meters.
1. Power Button
2. Transformation Switch
3. Return-to-Home (RTH) Button
4. Control Sticks
5. Status LED
6. Battery Level LEDs
7. Power Port
8. Mobile Device Holder
9. Antennas
10. Handle Bar
* The maximum flight speed and maximum run-time (hovering state) were tested in a lab environment, at zero-level elevation and in windless conditions, and
should be taken as reference only.
* The maximum transmission distance was tested in a lab environment, and will vary greatly depending on your immediate area.
Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.
Art des Missbrauchs:
Forenregeln
Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:
Lesen Sie zuerst die Anleitung;
Schauen Sie nach, ob die Frage bereits gestellt wurde;
Stellen Sie die Frage so deutlich wie nur einigermaßen möglich;
Erwähnen Sie was Sie bereits versucht haben um das Problem zu lösen;
Ist Ihr Problem von einem Besucher gelöst dann lassen Sie ihn / sie wissen in diesem Forum;
Falls Sie reagieren möchten, so verwenden Sie bitte das Antworten- Formular;
Da ihre Frage für alle Besucher sichtbar ist, sollten Sie lieber keine persönliche Daten erwähnen.
Neu registrieren
Registrieren auf E - Mails für DJI INSPIRE 1 PRO wenn:
neue Frage gestellt werden
neue Handbücher vorhanden sind
Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.
Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.
Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.
Ihre Frage wurde zu diesem Forum hinzugefügt
Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.
