Bedienungsanleitung DJI Inspire 2 series - 2019 (Seite 16 von 75) (Englisch)

719093

Zoom out

Zoom in

Vorherige Seite

1/75

Nächste Seite

INSPIRE 2

SERIES User Manual

Warning

Fast yellow ashing Remote Controller Signal Lost

Slow red ashing Low Battery Warning

Fast red ashing Critical Low Battery Warning

Red ashing IMU Error

—

Solid Red Critical Error

Fast alternating red and yellow ashing Compass Calibration Required

* Slow green ashes indicate P-Mode and fast green ashes indicate S-mode.

Return-to-Home (RTH)

Return-to-Home (RTH) function brings the aircraft back to the last recorded Home Point. There are

three types of RTH: Smart RTH, Low Battery RTH, and Failsafe RTH. This section describes these

three scenarios in detail.

GPS

Description

Home Point

If a strong GPS signal was acquired before takeoff, the Home Point is

the location from which the aircraft launched. The GPS signal strength is

indicated by the GPS icon (

Less than 4 bars is considered a weak

GPS signal.). The aircraft status indicator will blink rapidly when the home

point is recorded.

The aircraft can sense and avoid obstacles when the Forward Vision System is enabled and

lighting conditions are sufcient. The aircraft will automatically climb up to avoid obstacles and

descend slowly as it returns to the home point. To ensure the aircraft returns home forwards, it

cannot rotate or y left and right during RTH while the Forward Vision System is enabled.

Smart RTH

Use the RTH button on the remote controller or tap the RTH button in the DJI GO 4 app and

follow the on-screen instructions when GPS is available to initiate Smart RTH. The aircraft will

then automatically return to the last recorded Home Point. Use the remote controller to control the

aircraft’s speed or altitude to avoid a collision during the Smart RTH process. As the aircraft returns,

it will use the primary camera to identify obstacles as far as 300m in front, allowing it to plan a safe

route home. Press and hold the Smart RTH button once to start the process, and press the Smart

RTH button again to terminate the procedure and regain full control of the aircraft.

Low Battery RTH (Can be turned off in DJI GO 4 app)

The low battery level failsafe is triggered when the DJI Intelligent Flight Battery is depleted to a point

that may affect the safe return of the aircraft. Users are advised to return home or land the aircraft

immediately when prompted. The DJI GO 4 app will display a notice when a low battery warning

is triggered. The aircraft will automatically return to the Home Point if no action is taken after a ten-

second countdown. The user can cancel the RTH procedure by pressing the RTH button on the

remote controller. The thresholds for these warnings are automatically determined based on the

aircraft’s current altitude and distance from the Home Point. If the RTH procedure is cancelled

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

DJI Inspire 2 series - 2019 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von DJI Inspire 2 series - 2019

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info