Bedienungsanleitung Dogtrace d-control professional 1000 One (Seite 12 von 20) (Englisch)

766076

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Choice of the contact points

The stimulation is transferred on your dog‘s skin through the steel contact points

of the receiver. Each set contains 2 types of contact points. Sucient length of the

contact points has to have a contact with the dog‘s skin, enabling the device to

operate correctly. If you have a short-haired dog use the 7 mm and 10 mm contact

points supplied in the kit. Screw the contact points onto the screws of the receiver

- see the picture Receiver in the chapter Product description, page 7. Tighten them

carefully manually (do not use a pliers – this could damage the product).

Fitting the collar

The strap (receiver collar) with the receiver collar must be tightened enough so that

the contact points are in contact with the skin of the dog. We recommend you to t

the collar on the standing dog. When you can t two ngers between the collar and

your dog‘s neck, the collar with the receiver are tightened enough. If a dog has long

or thick hair, it is suitable to trim the hair in the area of the contact points or to switch

to the longer contact points to ensure a consistent contact.

4. After 5 seconds the receiver LED indicators will ash 3 times green and red colour

simultaneously. Afterwards the green and red LED indicators will start alternately

ashing.

5 Press down B1 or B2 button (or any other function button on the second

transmitter).

6. Successful pairing is indicated by a long beep tone of the receiver.

Warning: If you program the receiver from the switched OFF status (see the

chapter Programming function buttons A1/A2 with the rst receiver), the device

that was programmed from the switched ON status will be automatically

removed (mostly used to remove the trainer‘s transmitter from your receiver after

the training is nished).

TIP: If your dog has very long hair, you can order 12, 17 or 21 mm long contact

points. If your dog has a dry skin in the area where the contact points are, it is

good to lubricate the dog‘s skin with a vaseline, hand cream, or baby oil - which

enables a correct transfer of stimulation impulses.

Warning: If the collar is too loose, the receiver is likely to move and repeating

friction can irritate the skin of your dog. Furthermore, in this case it is not ensured

a reliable contact of contact points with the skin and a proper function of the

training collar. We do not recommend to leave the collar positioned at the

same place for more than several hours, because it could irritate the skin. If it is

necessary to wear the collar for long periods, change regularly the position on the

neck of your dog. A collar with a receiver that is overly tight, can cause pressure

sores on the skin in the contact area of the contact points. If this happens, do not

use the training collar until all traces of irritation are gone.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dogtrace d-control professional 1000 One Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info