Bedienungsanleitung Dolmar PM-461 (Seite 14 von 25) (Englisch, Holländisch)

507674

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

13. TROUBLE SHOOTING

14. ENVIRONMENT

Should your machine need replacement after extended

use, do not put it in the domestic waste but dispose of it in

an environmentally safe way.

For European countries only

EC Declaration of Conformity

The undersigned, Tamiro Kishima and Rainer

Bergfeld, as authorized by Dolmar GmbH, declare that

the DOLMAR machine(s):

Designation of Machine: Petrol Lawn Mower

Model No./ Type: PM-411, PM-461

Specifications: See “4. TECHNICAL DATA”

are of series production and

Conforms to the following European Directives:

2006/42/EC, 2004/108/EC,

2000/14/EC & 2005/88/EC

And are manufactured in accordance with the following

standards or standardised documents:

EN836, EN ISO14982

The technical documentation is on file at:

Dolmar GmbH,

Jenfelder Straße 38, Abteilung FZ,

D-22045 Hamburg

PROBLEM PROBABLE CAUSE CORRECTIVE ACTION

Engine does not start.

Throttle choke not in the correct

position for the prevailing conditions.

Move throttle choke to correct position.

Fuel tank is empty.

Fill tank with fuel: refer to ENGINE OWNER’S

MANUAL.

Air cleaner element is dirty.

Clean air cleaner element: refer to ENGINE

OWNER’S MANUAL.

Spark plug loose. Tighten spark plug to 25 - 30 Nm.

Spark plug wire loose or disconnected

from plug.

Install spark plug wire on spark plug.

Spark plug gap is incorrect. Set gap between electrodes at 0.7 to 0.8 mm.

Spark plug is defective.

Install new, correctly gapped plug: refer to ENGINE

OWNER’S MANUAL.

Carburetor is flooded with fuel.

Remove air cleaner element and pull starter rope

continuously until carburetor clears itself and install

air cleaner element.

Faulty ignition module. Contact Dolmar authorised service centre.

Engine difficult to start or

loses power.

Dirt, water, or stale fuel tank.

Drain fuel and clean tank. Fill tank with clean, fresh

fuel.

Vent hole in fuel tank cap is plugged. Clean or replace fuel tank cap.

Air cleaner element is duty. Clean air cleaner element.

Engine operates

erratically.

Spark plug is detective.

Install new, correctly gapped plug: refer to ENGINE

OWNER’S MANUAL.

Spark plug gap is incorrect. Set gap between electrodes at 0.7 to 0.8 mm.

Air cleaner element is dirty.

Clean air cleaner element: refer to ENGINE

OWNER’S MANUAL.

Engine idles poorly.

Air cleaner element is dirty.

Clean air cleaner element: refer to ENGINE

OWNER’S MANUAL.

Air slots in engine shroud are blocked. Remove debris from shots.

Cooling fins and air passages under

engine blower housing are blocked.

Remove debris from cooling fins and air passages.

Engine skips at high

speed.

Gap between electrodes of spark plug

is too close.

Set gap between electrodes at 0.7 to 0.8 mm.

Engine overheats.

Cooling air flow is restricted.

Remover any debris from slots in shroud, blower

housing, air passages.

Incorrect spark plug.

For PM-411, install RC12YC spark plug and cooling

fins on engine.

For PM-461, install RJ19LMC spark plug and

cooling fins on engine.

Mower vibrates

abnormally.

Cutting assembly is loose. Tighten blade.

Cutting assembly is unbalanced. Balance blade.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Dolmar PM-461 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info