!"#$%L&
The air conditioner will automatically
stop when the room temperature is beP
low the selected temperature.
2.2 Dehumidication mode (DRY)
- connect a drainage hose (not supP
plied) so that water is discharged contiP
+020/.D9
- press the MODE key to select the
dehumidication mode: the corresponP
ding LED lights up.
NOTE: The dehumidier runs contiP
nuously, the fan speed and temperature
cannot be changed (only «LOW» speed
is available).
2.3 Ventilation mode (FAN)
- press the MODE key to select the venP
tilation mode: the corresponding LED
lights up.
- Press the SPEED key successively to
select the (LOW) or (HIGH) fan speed:
the corresponding LED lights up.
3. SLEEP MODE KEY
IMPORTANT: This mode can only be
activated from the remote control, and
only in the cooling mode.
- from the cooling mode, if the SLEEP
mode is activated, the selected temP
perature increases by 1°C after 1 hour
of operation, then by an additional 1°C
after 2 hours. It will then remain at this
/$**(+#9
- all the LEDs switch off gradually, and
the fan automatically switches from
high speed to low speed.
NOTE: In dehumidication and ventilaP
tion mode, the sleep mode cannot be
/$.$1*$39
- In sleep mode, the fan speed remains
at «Low» speed, and cannot be chanP
#$39
4. SPEED KEY %
- Press the SPEED key successively to
select the (LOW) or (HIGH) fan speed:
the corresponding LED lights up.
NOTE: The fan speed cannot be chanP
ged when the dehumidication (DRY) or
sleep (
) modes are selected.
5. TIMER KEY%%
This key is used to turn the device on or
off from the programmable timer.
NOTE: the time that can be programP
med is from 1 to 24 hours.
START TIMER: The start timer key is
used to turn the device on at the end of
the programmed time.
1. In standby mode, press the «TIMER»
key to set the required time. The
TIMER indicator will light up and the
display will show 1 hour.
2. Repeatedly press the «INCREASE»
or «DECREASE» keys to display the
3$/()$3%*(-$9
3. If the «TIMER» key is not pressed for
a few seconds, the time display will
disappear and be replaced by the disP
play of the ambient temperature. The
timer is then activated.
4. At the end of the time set, the device
x(..%*0)+%2+%"0*2-"*(1"..D9
SLEEP TIMER: the sleep timer key is
used to put the device in standby at the
end of the programmed time.
1. While the air conditioning is in operaP
tion, press the «TIMER» key to deterP
mine the required time of operation.
The TIMER indicator will light up and
the display will show 1 hour.
